Fiilex FLXQ8CLR-Z Q8 Color User Guide
- June 6, 2024
- Fiilex
Table of Contents
Fiilex FLXQ8CLR-Z Q8 Color
Safety Instructions
• DO NOT look into the light source. Be cautious of the high-intensity beam.
• DO NOT disassemble Q8 Color. This will void the warranty.
• DO NOT install Q8 Color in damp or wet locations.
• DO NOT obstruct the fixture’s air vents.
• Use safety cable (not included) when rigging Q8 Color overhead.
• Only use Fiilex approved power supply and accessories. Failure to do so may
damage the fixture.
• Shields, lenses or ultraviolet screens shall be changed if they have become
visibly damaged to such an extent that their effectiveness is impaired, for
example by cracks or deep scratches.
• The lamp shall be changed if it has become damaged or thermally deformed.
• The luminaire is intended for professional use only.
Parts Diagram
- Vent Holes
- Water Repellent Fabric
- Yoke Bolt
- Tilt Lock Lever
- Beam Adjustment Knob (Spot to Flood)
- Yoke
- Mount Tightening Knob
- Junior Pin Receiver
- Latch
- Fresnel Lens
- Fresnel Lens Holder
- Power Supply Unit (PSU)
- USB Type-C Port (For updating firmware)
- USB Type-A Port (5V/1A Power)
- Intensity Control Knob
- CCT/HUE Knob
- LAN Port
- DMX Input (XLR-Male 5-pin)
- DMX Input (XLR-Male 5-pin) DC Input Port
- Dual Locking V-Mount
- OLED Display
- Navigation Pad
- GN/SAT Knob
- Handles
- ON/OFF Switch
- DMX Output (XLR-Female 5-pin)
Fixture Operation
-
Mode Selection
Use Navigation Pad to enter MODES menu, then navigate to select the desired mode.
-
Fixture Control
-
Manual / Local :
Use Intensity Control Knob or the Navigation Pad to control the parameters.
For CCT modes and HSI modes, use either CCT/HUE Knob and GN/SAT Knob or the Navigation Pad . -
DMX / RDM / Ethernet (ArtNet / sACN) :
Display shows DMX connection status, NO DMX or DMX OK.
-
Settings
Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access
additional settings.
Fan speed options
| Off | The fan is completely off. (Operation time is limited.) |
|---|---|
| Variable | The fan speed varies based on light intensity. |
| Silent | The fan operates at reduced speed. |
| Full Speed | The fan operates at full speed. |
Dimming options
| Sharp | Best for flash and strobe effects. |
|---|---|
| Smooth | Best for gradual fades. |
Ethernet
Modify ArtNet and sACN settings of the fixture.
Info
View current fixture firmware versions and fixture temperature.
1689 Regatta Blvd. Richmond, CA 94804
510-620-5155
fiilex@fiilex.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>