Fiilex 03282023A Quad Color User Guide
- October 30, 2023
- Fiilex
Table of Contents
03282023A Quad Color
User Guide
Safety Instructions
- DO NOT disassemble QUAD Color. This will void the warranty.
- DO NOT install QUAD Color in damp or wet locations.
- DO NOT obstruct the fixture’s air vents.
- Use safety cable (not included) when rigging QUAD Color overhead.
- Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
- The luminaire is intended for professional use only.
- Do not look into the light source with any instrument that could concentrate the light output: this includes magnifiers, binoculars, telescopes, etc.
- This fixture corresponds to Risk Group 1 according to EN 62471 under normal operation condition, which considers all photobiological risks. It corresponds to Risk Group 1 according to EN 62778 under those conditions, which considers risk from blue light only.
- The light output can potentially cause eye injury if stared at for a prolonged period of time
Parts Diagram
1. Fan Intake Vent
2. ON/OFF Switch
3. Vent Holes
4. Tilt Lock Lever
5. Yoke
6. USB Type-A Port (5V/1A Power)
7. DMX Iutput (XLR-Male 5-pin)
8. Junior Pin Receiver
9. Handle| 10. OLED
11. Intensity Control Knob
12. CCT/HUE Knob
13. GN/SAT Knob
14. Navigation Pad
15. USB Type-C Port (For updating firmware)
16. LAN Port
17. DMX Output (XLR-Female 5-pin)
18. AC Input Port
---|---
Fixture Operation
-
Mode Selection
Use
Navigation Pad to enter MODES menu, then navigate to select the desired mode. -
Fixture Control
1 Manual / Local:
Use Intensity Control Knob or the Navigation Pad to control the parameters.
For CCT modes and HSI modes, use either CCT/HUE
Knob and GN/SAT Knob or the Navigation Pad .
2 DMX / RDM / Ethernet (ArtNet / sACN) :
Display shows DMX connection status, NO DMX or DMX OK.
Settings
Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access
additional settings.
- Fan speed options
Off| The fan is completely off. (Operation time is limited.)
---|---
Variable| The fan speed varies based on light intensity.
Silent| The fan operates at reduced speed.
Full Speed| The fan operates at full speed. - Dimming options
| Sharp | Best for flash and strobe effects. |
|---|---|
| Smooth | Best for gradual fades. |
-
Ethernet
Modify ArtNet and sACN settings of the fixture.
-
Info
View current fixture firmware versions and fixture temperature.
1689 Regatta Blvd. Richmond, CA 94804
(510) 620-5155
[email protected]
www.fiilex.com