Fiilex FLXQ8CLR-Z Q8 Color LED Fresnel Travel Kit User Guide
- June 6, 2024
- Fiilex
Table of Contents
Fiilex FLXQ8CLR-Z Q8 Color LED Fresnel Travel Kit User Guide
Safety Instructions
- DO NOT look into the light source. Be cautious of the high-intensity beam.
- DO NOT disassemble Q8 Color. This will void the warranty.
- DO NOT install Q8 Color in damp or wet locations.
- DO NOT obstruct the fixture’s air vents.
- Use safety cable (not included) when rigging Q8 Color overhead.
- Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
- Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that their effectiveness is impaired, for example by cracks or deep scratches.
- The lamp shall be changed if it has become damaged or thermally deformed.
- The luminaire is intended for professional use only
Parts Diagram
- Vent Holes
- Water Repellent Fabric
- Yoke Bolt
- Tilt Lock Lever
- Beam Adjustment Knob (Spot to Flood)
- Yoke
- Mount Tightening Knob
- Junior Pin Receiver
- Latch
- Fresnel Lens
- Fresnel Lens Holder
- Power Supply Unit (PSU)
- USB Type-C Port (For updating firmware)
- USB Type-A Port (5V/1A Power)
- Intensity Control Knob
- CCT/HUE Knob
- LAN Port
- DMX Input (XLR-Male 5-pin)
- DMX Input (XLR-Male 5-pin)
- DC Input Port
- Dual Locking V-Mount
- OLED Display
- Navigation Pad
- GN/SAT Knob
- Handles
- ON/OFF Switch
- DMX Output (XLR-Female 5-pin)
Fixture Operation
- Mode Selection
Use Navigation Pad to enter MODES, then navigate through modes and select the desired mode.
- Fixture Control
- Manual / Local :****
Use Intensity Control Knob and/or the Navigation Pad to control the parameters. For CCT modes and HSI modes, use either CCT/HUE Knob and GN/SAT Knob or the Navigation Pad .
- DMX / RDM / Ethernet (ArtNet / sACN) :
Display shows DMX connection status, NO DMX or DMX OK.
Settings
Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access additional settings.
-
Fan speed options
-
Dimming options
-
Ethernet
Modify ArtNet and sACN settings of the fixture. -
Info
View current fixture firmware versions and fixture temperature.
1689 Regatta Blvd. Richmond, CA 94804 |
510-620-5155 |
fiilex@fiilex.com
www.fiilex.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>