SDC 7100 Yale Electric Latch Retraction Device Kit Installation Guide
- June 6, 2024
- SDC
Table of Contents
SDC 7100 Yale Electric Latch Retraction Device Kit Installation Guide
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
INSTALLATION INSTRUCTIONS
LR100YDK
YALE ELECTRIC LATCH RETRACTION DEVICE KIT
MODELS: 7100, 7100-2, 7110, 7120, 7200 & 7210
Replace Housing Cover, Cover with Plug,
End Cap and the End Cap Cover.
When retrofitting to existing vertical rod devices, adjustment of the rods is required for proper operation of the Electric Latch Retractor. Once the unit is properly installed, energize it so the latch is dogged down, then reconnect the vertical rods to the device and make the proper adjustments.
Retrofit Installation Note : 42″ or 48″ exit devices that have been modified to fit a 36″ or smaller opening, may not have the required space to fit the standard E. L. R. assembly. Always verify the distance from the end of the touchpad to the end rail, and if necessary, consult with the factory for appropriate selection.
Any suggestions or comments to this instruction or product are welcome. Please contact us through our website or email engineer@sdcsecurity.com
P:\INST INSTRUCTIONS\ELR Kits\INST-LR100YDK REV L 11-20
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>