DEWERTOKIN RF5119 Remote Control User Manual

: June 6, 2024
: DEWERTOKIN

Table of Contents

Read User Manual Online (PDF format)
Download This Manual (PDF format)

1 appearance

Key-value|

Specification

---|---
PAIR| press and hold button ,the remote enters pairing mode, backlight LED flashes, When the pair succeeds, the backlight stops flashing then normally on.
HEAD UP| Press and hold button, the head actuator moves out, stop when released
HEAD DOWN| Press and hold button, the head actuator moves in, stop when released
FOOT UP| Press and hold button, foot actuator moves out, stop when released
FOOTDOWN| Press and hold button, foot actuator moves in, stop when released
FLAT| Click button, the bed goes flat
Lock| Press and hold the button for 5s until the backlight flashes, then the lock/unlock is complete.
ZG| Click the button, the bed moves to zero position, press and hold zero buttons for 5s, until backlight flashes, the control set the current position as zero position
TV/PC| Click the button, the bed moves to TV/PC position, press and hold TV/PC button for 5s, until backlight flashes, the control set the current position as TV/PC position
UNDER BED LIGHT| Click button, the under bed light switch its on/off state;
After the under bed light opens, if do not manually close, it will automatically turn off after 5 minutes;
M1| Click the button, the bed moves to M1position, press and hold M1 button for 5s, until backlight flashes, the control set the current position as M1 position
M2| Click button, the bed moves to M2 position, press and hold M2button for 5s, until backlight flashes, the control set the current position as M2 position
FLASHLIGHT| Press and hold button, open flashlight, close when released
MASSAGE HEAD+| Click button, head massage motor switch its intensity among 1-2-3-0-1
MASSAGE FOOT+| Click button, foot massage motor switch its intensity among 1-2-3-0-1
TIMER| If the massage motors do not work, the button is invalid, if the massage motors work, click the button to switch the massage time, when massage time switch to 0, turn off the massage;
MASSAGE HEAD-| Click button, head massage motor switch its intensityamong3-2-1-0-3
MASSAGE FOOT —| Click button, foot massage motor switch its intensityamong3-2-1-0-3
MASSAGE TYPE| Click button, to switch the massage mode of massage motors, massage mode switches among type0> type1> type2> type3type0; this button can only switch the massage mode, it can not open massage motors；

FCC Statement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.

ISED RSS Warning/ISED RF Exposure Statement ISED RSS Warning:

This device complies with Innovation, Science, and Economic Development Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirements.