Canon 247 Z-Wave PCB Unit User Manual
- June 6, 2024
- Canon
Table of Contents
247 Z-Wave PCB Unit
User Manual
This is a user manual for host product manufacturers to use when integrating
the module in a host product.
For the module installation to host systems, please follow the instruction
below.
- Insert the FPC or FFC into the connector on the board. The contact of the connector is the bottom contact (board side). Please refer to the circuit diagram for the pin arrangement of the connector.
- Align the two holes on the board with the two holes on the main unit side.
- Tighten the board and the main body together using two screws. Use M2 screws for the screws.
Note: This module is certified as limited modular approval as it does not
have its own power supply regulator, therefore regulated 3.3V must be supplied
by a host device using voltage regulator, e.g. TLV62084ADSG (Vout
3.3V+-0.12V/Iout >= 0.25A) or equivalent.
The device shall be installed as described above and is designed to use an
integrated antenna. Do not modify the antenna or any other part of the module.
Any modifications will invalidate the modular certifications and require new
approvals for the host system.
This device complies with part 15 of the FCC Rules.
Part 15 Subpart C
The modular transmitter is only FCC authorized for the specific rule parts
(i.e., FCC transmitter rules) listed on the grant (FCC Part 15.249), and the
host product manufacturer is responsible for compliance with any other FCC
rules that apply to the host not covered by the modular transmitter grant of
certification. The final host product still requires Part 15 Subpart B
compliance testing with the modular transmitter installed.
FCC/ISED Notice for model: NCA01A
The end product must be labeled “Contains FCC ID: AZD247” and “Contains ISED
Certification Number: 498J-247” Following statement must be included in the
user manual of the host device.
FCC/ISED NOTICE
Model: ZWAVE Module Model NCA01A, FCC ID: AZD247/IC:498J-247)
This device complies with part 15 of FCC Rules and Industry Canada’s license-
exempt RSS. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be required to stop the operation of the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>