V-TAC 80133970 LED Spot Light Instruction Manual
- June 17, 2024
- V TAC
Table of Contents
WEEE Number: 80133970
INSTRUCTION MANUAL
LED SPOT LIGHT
TECHNICAL DATA
| MODEL | VT-7007 |
|---|---|
| SKU | 23182, 23183, 23184 |
| USEFUL LUMENS | 660 LM @Sphere 360° |
| INPUT VOLTAGE | AC: 220-240V, 50hz |
| POWER | 7W |
| BEAM ANGLE | 60° |
| LIFE SPAN | 20,000 Hours |
| ON/OFF CYCLE | >15,000 Times |
| PROTECTION RATING | IP20 |
| INPUT VOLTAGE | AC: 100-265V, 50/60Hz |
| UNIT COLOUR | White |
| MATERIAL | PC |
| DIMENSION | Ø86×20 mm |
| CUT OUT SIZE | Ø65 mm |
INTRODUCTION & WARRANTY
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at the best. The warranty is valid for 2 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.
WARNING
- Please make sure to turn off the power before starting the installation.
- Installation must be performed by a qualified electrician.
- The light source of this luminaire is not replaceable, when the light source reaches its end of life the whole luminaire should be replaced.
- If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
- For Indoor use only
MULTI-LANGUAGE MANUAL QR CODE
Please scan the QR code to access the manual in multiple languages.
This marking indicates that this product should not be disposed of with other household wastes.
Caution, risk of electric shock.
INSTALLATION INSTRUCTION
- Switch off the power before starting the installation.
- Mark the area for making hole).
- Cut a hole as per the Cut Out Size – Ø65 mm(Figure 2).
- Connect the AC connection to the driver (Figure 3).
- Hold the two clips back against the sides of the spot light and push up into the hole. The clips then lie flat on top of the ceiling holding it in place (Figure 3).
- Turn on the power and test.
In case of any query/issue with the product, please reach out to us at:
[email protected]
For More products range, inquiry please contact our distributor or nearest
dealers.
V-TAC EUROPE LTD. Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B