GOLOZA Digital Alarm Clock for Bedrooms User Guide
- June 15, 2024
- GOLOZA
Table of Contents
GOLOZA Digital Alarm Clock for Bedrooms
Time Setting
Toggle the switch to “r1ME”, and short press to adjust the time. Long press to quickly adjust, the hour changes with the minute.
After the setting is finished, toggle the switch to “LOCK” to save the
setting. 
Note: In time display mode, short press to switch 12/24-hour time display format.
Alarm Setting
Alarm Time Setting
Toggle the switch to· ALARM”, and short press to adjust the time. Long press
to quickly adjust, the hour changes with the minute.
Note : The alarm icon will display after the alarm is turned on.
Alarm Ringtones Setting
In time display mode, short press to choose the ringtone, and press again to
the next ringtone. There are three ringtones to choose: birdsongs, chording
and beep.
Note: Each ringtone will automatically turn off after 5 seconds, and the last playing sound will be automatically saved as the alarm ringtone.
Alarm Volume Setting
Toggle the switch to to choose low volume.
Toggle the switch to to choose high volume.
Toggle the switch to , the alarm will no longer ring.
Note: The alarm icon will disappear after the alarm is turned off.
Alarm Off
When the alarm goes off, short press to turn off the alarm. The alarm will ring for 30 minutes if it is no operation.
Snooze Function
When the alarm goes off, short press the “Cllt” button to temporarily turn off
the alarm, and the “Zzz” icon will show on the bottom right corner of the
display. The alarm will go off again after 9 minutes.
NOTE: In time display mode, press to adjust the display brightness
FCC
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, according to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>