Double E E324-003 Remote Control Car Climbing Toy Car User Manual

June 6, 2024
Double E

USER MANUAL

Main Parameters Item

No. : E324-003
Material: plastic and electronic components
Batteries: Car battery: 1pc of 4.8 V AA rechargeable battery
Remote controller battery:2pcs of 1. 5V AA batteries
Double E E324 003 Remote Control Car Climbing Toy Car

B attery Installation

  1. 0pen the battery cover of the remote controller as Fig 2A showed, inserts 2pcs of 1. 5V AA batteries, and then screw the cover.
  2. Open the cover under the truck by screwdriver, inserts 1pc of 4. 8V AA rechargeable battery as the correct polarity, and then screw the cover. (Fig 2B)

Double E E324 003 Remote Control Car Climbing Toy Car -
fig

Double E E324 003 Remote Control Car Climbing Toy Car - fig
1 Notice: first charging requires 8 hours, future charging requires 4 to 5 hours.

Double E E324 003 Remote Control Car Climbing Toy Car - fig
2Double E E324 003 Remote
Control Car Climbing Toy Car - fig 3 Basic Operation and Functions

  1. Forward/Backward: To push the Trigger back/ahead, the truck would go forward/backward. (Fig 4B)
  2. Turn Left/Right: To push the Trigger forward/ backward, and Control Wheel turns left/right, the truck would turn left/right. (Fig 4C)

These functions could be multiple used for simulating operations.

Recharging

Notice: Please turn the power switch to “OFF position if the product will not be used for a long time Take the batteries out of the remote controller and the excavator if they are stored for a long time Charge the battery for about 4 to 5 hours, but it charges for 8 hours before initial use.

Notice

  1. Don’t play with the toy on the road, select a safe place for operating to avoid danger.
  2. Plays the toy in water may cause short circuit damage. Please use a dry cloth to clean the car.
  3. If abnormal speed or reaction, it may be because of insufficient battery power, please charge the battery.
  4. The batteries should be charged under adult supervision. Please use the batteries recommended.
  5. Please install the battery in the correct polarity.
  6. Do not mix new and old batteries together, short-circuited.
  7. Please charge the battery before initial use.
  8. Don t break the remote control antenna to prevent injury.
  9. Please check the plug case and other units of charger regularly to make sure that it is not broken. Don’t use it again if you find any abnormality in the charger.
  10. Please do not connect the product to different performance power.

Hereby, Doubleeagle Industry(China)Limited, declares that this [type of equipment] is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www. double-eagle. cn
CHOKING HAZARD -small parts, not for children under 3 years.
Specifications colors and contents may vary from illustrations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class 13 digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals