Double E SY-E579-003-03 Radio Control Toys User Manual

June 5, 2024
Double E

SY-E579-003-03 Radio Control Toys
User Manual

Main parameters

Item No.: E579-003
Material: plastic and electronic components
Batteries: Car battery: 3.7V rechargeable battery; Remote controller battery: 2 pcs of 1.5V AA batteries.

Double E SY E579 003 03 Radio Control Toys - figure 1

Battery Installation

  1. Open the cover of the battery case located at the back of the controller, insert 1 pcs of 3.7V batteries into the battery case, and then screw the cover (Fig 2A).
  2. Please screw out the cover at the back of the car with a screwdriver, open the cover as the arrow shows, insert 2 pcs of 1.5 V AA batteries, then screw the cover (Fig 2B).
    Double E SY E579 003 03 Radio Control Toys - figure 2

Notice: This product shall be charged for two to three hours. The supporting USB charger shall not be used for other devices other than this product. When the USB charger is connected to the power,the indicator light on. When the USB charger and battery are being charged, the indicator will be flashing, it will be off after full charged (Fig 2C).

2.4G Auto Coding

  1. After installing the batteries of the car and remote controller, open the switch of both. The indicator of the remote controller and the front lights of the car would be flashing slowly, and then at a state of auto-coding.
  2. One remote controller only could code with one car. After the success of coding, there is a non-interference of each car.
  3. If the remote controller could not find out the 2.4G signal of the car in 1 minute, it would turn in a sleeping state (light off of the indicator). Press any key to activate. To remake a pair with other cars or remote controllers after turning off the power of both.

Operating Instructions for the controller

  1. Turn ON/OFF
    • Press any key, and there will be a startup sound; Without receiving any remote-controlled signals after starting, the car would auto off in 60 seconds. (Fig 3A)
    Double E SY E579 003 03 Radio Control Toys - figure 3

  2. Horn Key
    • To press the Horn Key on the remote controller after starting the car, the car would emit a simulated sound.

  3. Forward/Backward
    • To push the Left Handle forward/backward, the car would go forward/backward.

  4. Turn Left/Right
    • To push the Left Handle forward/backward, the Right Handle turns left/right, and the car would turn left/right. (Fig 3C).

  5. Bucket up/down
    • Press the up button, bucket up, down button, bucket down, up /During the descending operation, the car lights are on (fig 3D).

  6. Manually loosen the harrow
    • The soil scraper can be manually moved up and down (fig 3E).

Advanced Functions

  1. Mute Switch
    After starting the fire truck, to pressing the Horn key for a long time, the car could change to a mute condition. To press the Horn key again, it could be switched to the sound station.

  2. Program Function
    To press the Programme Key when starting, after the indicator turns red, the car is in a state of Programme, you could do a series of motions as you like, and these motions would be saved. To press the Programme Key again, the fire truck would automatically operate the motions.

  3. Auto OFF
    Without receiving any remote-controlled signals after starting, the car would auto-off in 50 When turned off, the car would with a DI sound, and all the functions are at a state of standby. It only could be operated after restarting.

  4. Athletics Function
    There are three channels A/B/C in the remote controller and the fire truck, so more than two players could play together by choosing a different channel.

Recharging

Notice: please turn off the power of the remote controller and car if the product would not be used a long time, make sure to take out batteries before storing. Please charge the battery for 2 to 3 hours.

Notice

  1. Don’t play with the toy on the road, select a safe place for operating to avoid danger.
  2. Plays the toy in water may cause short-circuit damage. Please use a dry cloth to clean the car.
  3. If abnormal speed or reaction, maybe because of insufficient battery power, please charge the battery.
  4. The batteries should be charged under adult supervision. Please use the batteries recommended.
  5. Please install the battery in the correct polarity.
  6. Do not mix new and old batteries together, may cause short-circuited.
  7. Please charge the battery before initial use.
  8. Please check the plug, case, and other units of charger regularly to make sure that it is not broken. Don’t use it again if you find an abnormality of the charger.
  9. Please do not connect the product to different performance power.

Frequency bands: 2402MHz to 2480MHz
Maximum output power: -0.22dBm (for EU compliance)
Manufacturer: Doubleeagle Industry(China)Limited.
Address: Xingda Industrial Park, Chenghai
District, Shantou City, Guangdong Province, China.
Importer: JAMARA e.K.
Address: Inh.Manuel Natterer
Am Lauerbuhl5-DE-88317 Aichstetten Germany
CHOKING HAZARD-small parts, not for children under 3 years.

FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try  to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
    Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals