Double E E571-003 Remote Control User Manual
- June 5, 2024
- Double E
Table of Contents
Double E E571-003 Remote Control
Main Parameters
Item No. : E571-003
- Material: plastic and electronic components
- Batteries: Car battery: lpc of 3.6V AA rechargeable battery
- Remote controller battery: 2pcs of 1. SV AA batteries
Battery Installation
- Open the battery cover of remote controller as the showed, inserts 2pcs of 1. SY AA batteries and then screws the cover.
- Open the cover under the truck by a screwdriver, inserts the LPC of 3.6V AA rechargeable battery as the correct polarity, and then screw the cover.
4G Auto Coding
- After installing the batteries of truck and remote controller, open the remote controller switch. The light at the front end of the remote controller’s indicator will flicker slowly and then automatically code, meaning the automatic encoding succeeds.
- One remote controller only could code one car. After the success of coding, there is non-interference of each car.
- If the remote controller could not find out the 2.4G signal of the car in lminute, it would turn in a sleeping state(light off of the indicator). To press any key to activate.
- To remake a pair with other cars or remote controllers after turning off the power of both.
Basic Operation and Functions
- Forward/backward:To push the Left Trigger ahead/ back, the truck would go forward/backward.
- Turn Left/Right:To push the Left Trigger forward/backward, and Right Trigger turns left/right, the truck would turn left/right.
- Excavating: press the key of “Excavating” after starting the car, the car will do a motion.
- Unloading: press the key of “Uoloading” after starting the car, excavator will do a motion.
- Left/Right Rotation: press the key of “Left(or Right) Rotation”, excavator will do a motion of left (or right) rotation. Auto-OFF: after starting the excavator, the car will automatically shut down without receiving any controlling signal in 60 seconds. then all the functions are at a status of standby.
Notice
- Don’t play the toy on the road, select a safe place for operating to avoid dangerous.
- Plays the toy in water may cause short circuit damage. Please use the dry cloth to clean the car.
- If abnormal speed or reaction, it may be because of insufficient battery power, please charge the battery.
- The batteries should be charged under adult supervision. Please use the batteries recommended.
- Please install the battery in a correct polarity.
- Do not mix new and old batteries together, short-circuited.
- Please charge the battery before initial use.
- Please check the plug case and other units of charger regularly to make sure that it is not broken. Don’t use again if you find abnormality of the charger.
- Please do not connect the product to different performance power.
CHOKING HAZARD- small parts, not for children under 3 years. Specifications colors and contents may vary from illustrations
- Frequency bands : 2402MHz to 2480MHz
- Maximum output power: -8.45dBm (for EU compliance)
- Manufacturer: Doubleeagle Industry (China) Limited.
- Address: Xingda Industrial Park, Chenghai
- District, Shantou City, Guangdong P rovince, China.
- Importer: JAMARA e.K.
- Address: lnh. Manuel Natterer
- Am Lauerbuhl 5 – DE-88317 Aich stetten Germany
FCC STATMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>