Double E E526-003 Radio Control Toys User Manual
- June 5, 2024
- Double E
Table of Contents
Double E E526-003 Radio Control Toys
Main parameters
- Item No.: E526-003
- Material: plastic and electronic components
- Batteries: Car battery: 4.8V AA rechargeable battery;
- Remote controller battery: 2 pcs of 1.5V AA batteries.
Battery Installation
- Open the cover of battery case locates in the back of controller, inserts 2 pcs of 1.5V AA batteries into the battery case, and then screw the cover (Fig 2A).
- Please screw out the cover at the back of car by screwdriver, open the cover as the arrow showed, insert lpcs of 4.8 V AA battery, then screw the cover (Fig 2B)
Notice: This produ ct shall be charged for two to th ree hours.The supporting USB charger shall not be use d for other devices other than this produ ct.
2.4G Auto Coding
- After insta lling the batteries on the car and the remote controller, turn on the power of both . There is a sound of DI from the car, and the indicator on the remote controller and the lights on the car would be flashing slowly. That means the car is in a sta te of coding, the auto-coding would be successful if the car with DI-DI sound.
- .Each remote controller could be only coded with one car. There is no any interference if auto-coding is success.
- It could be re-au to-coded with other car or remote controller by turning off the power of both.
Basic Operation & Functions
-
Turn ON/OFF Press the ON/OFF key, there will be a start-up sound; to press the key again after starting. (Fig 3A)
-
HornKey To press the Horn Key on remote controller after starting the car, the car would emit a simulated soun d .
-
Forward/Backward To push the Left Handle forward/backward, the car would go forward/backward.(Fig 3B)
-
Turn Left/ Right To push the Left Handle forward/backward, Right Handle turns left/right, the car would turn left/righ t. (Fig 3C).
-
660 degree Rotation of Operation Station After starting the car, to press the Left/Righ t Rotation, the Operation station would do a motion of left/right rotation with soun d . (Fig 3D).
-
Up &Down, In&Out of Crane Arm After starting the car, to press the key of Up&Down of Crane Arm, the arm of the crane would raise up (come down) slowly; at the same time, the second arm would hand over(
draw back)slowly with a series of mechanical sound. (Fig 3E) 360 degree Rotation -
Up &Down of Hook After starting the crane, press the Hook Up(Down) key, the hook of the crane would raise up (come down) slow ly with a mechanical sound . (Fig 3E) These functions could be multiple used for simulating operation
Advanced Functions
Mute Switch
After starting the truck, to press the Horn key for a long time, the car could
change to a mute condition. To press the Horn key again, it could be switched
to the sound station.
DEMO Function
To press the DEMO key, the car could operate a series of the functions automatically; to exit this function through pressing any key.
Auto off
After turning on the remote controller, the car would be auto off withou t
receiving any signal from the remote controller by 60sec.
Braking Function
When the car goes forward/backward, to change the direction directly, the car
would be with braking sound and motion.
Multi-playing function
The product is remote controlled by 2.4GHz, so many cars could be p layed
together by players.
Recharging
Notice: Please push the power switch to “OFF” position if the product will not be used for a long time. Take the batteries out of the remote controller and the truck for storing. Please charge the battery for 4 to 5 hours, 8 hours for initial use.
Notice
- Don’t play the toy on the road , select a safe p lace for operating to avoid dangerous.
- Plays the toy in water may cause shor t-circuit damage. Please use the dry cloth to clean the car.
- If abnormal speed or reaction, it may be because of insufficient battery power, please charge the battery.
- The batteries should be charged under adult supervision. Please use the batteries recommended.
- Please install the battery in a correct polarity.
- Do not mix new and old batteries together, short-circuited.
- Please charge the battery before initial use.
- Please check the plu g, case and other un its of charger regularly to make sure that it is not broken.Don’t u se again if you find abnormality of the charger.
- Please do not connect the product to different performance power.
- Frequency bands : 2405MHz to 2475MHz
- Maximum output power : -3 .15dBm (for EU compliance)
- Manufacturer; Doubleeagle Industry (China) Limited.
- Address: Xingda Industrial Park , Chenghai
- District, Shantou City, Guangdong Province , China .Importer: JAMARA e.K.
- Address : lnh . Manuel Natte rer Am Lauerb i.i hl 5 – DE-88317 Ai chstetten Germany
**CHOKING HAZARD
**
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>