Roman And Isaac B08LNWQKFC And Isaac Rustic Wooden Floating Shelf Installation Guide
- June 1, 2024
- Roman And Isaac
Table of Contents
B08LNWQKFC And Isaac Rustic Wooden Floating Shelf
Product Information
Specifications:
-
Brand: Roman & Isaac
-
Product: Floating Shelf
-
Tools Required: Electronic drill with hammer function/masonry
drill, 10mm masonry drill bit, Spirit level & pencil, Tape
measure, Masking tape, Adjustable spanner or open end 10mm
spanner -
Installation: Wall-mounted
Product Usage Instructions:
1. Preparation:
Start by placing masking tape on the wall where you want to
position the shelf. Ensure the tape is wide enough for marking.
2. Marking and Drilling:
Use a spirit level to draw a straight line on the tape. Mark
drill holes 35cm apart along this line. Drill 65mm deep holes using
a 10mm masonry drill bit.
3. Bracket Installation:
Insert plastic wall-plugs into the drilled holes. Attach washers
to screws, insert supports into holes, and tighten with a
spanner.
4. Shelf Placement:
Ensure brackets are level and horizontal using a spirit level.
Slowly push the shelf onto the brackets. Adjust the bracket with a
spanner to secure the shelf in place.
5. Safety Recommendations:
Mount shelves at safe heights, especially in areas accessible to
children. For heavier items or child-accessible areas, consider
additional oak battens for support.
Frequently Asked Questions (FAQ):
Q: Can I install the shelf without using a spirit level?
A: While a spirit level ensures correct alignment, you can
visually check for levelness if needed. However, using a spirit
level is recommended for best results.
Q: Do I need to use all the tools listed for installation?
A: Yes, it is recommended to use all the specified tools for
proper installation and secure mounting of the floating shelf.
ROMAN & ISAAC
Floating Shelf Fitting Instructions
Bracket Dimensions
Tools & Equipment Required
Electronic drill with hammer function / masonry drill 10mm masonry drill bit
Spirit level & pencil Tape measure Masking tape
Adjustable spanner or open end 10mm spanner
Start by placing masking tape on the wall where you are planning on
positioning your new shelf. Make sure the strip of tape is wide enough to
allow you to properly mark the wall.
Next, use the spirit level to mark a straight line across the masking tape
with your pencil.
Using your tape measure, mark the holes on the line you have drawn, 35cm apart
– these will be your drill holes.
Insert your 10mm masonry drill bit in to the drill and make sure it is held in
tightly. Be sure to use eyeprotection, then drill a hole of 65mm deep at each
point marked. Ensure the drill is straight and that you apply pressure evenly
when drilling.
Insert the plastic wall-plug included with the bracket into the holes you’ve
drilled and push in to the wall until flush.
Next, put the washer onto the screw-end of the shelf brackets, and then insert
the supports in to the holes, using a spanner to tighten them up sufficiently.
Use a spirit level to ensure that the brackets are pointing out of the wall
straight and horizontally, so that you can be sure your shelf will sit flat.
Finally, you’re ready to push the shelf on to the brackets. Take care, proceed
slowly and check once more with the spirit level to ensure that your shelf is
flat. Prior to pushing the shelf against the wall, finely adjust the bracket
using the spanner so that the off-set cam rotates and touches the inside of
the holes. This holds the shelf in place.
Please take care when installing to ensure that the shelves are mounted at suitable and safe heights (particularly in areas that children may frequent). Similarly, if you feel there is a possibility that you will be storing moderately heavy items on the shelving, or that these will be placed in areas utilised by children, we recommend purchasing additional oak battens for extra support.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>