DOUBLE E E571-003 Mini Remote Control Excavator User Manual
- June 1, 2024
- Double E
Table of Contents
DOUBLE E E571-003 Mini Remote Control Excavator
Main Parameters
Item No. : E571-003
Material: plastic and electronic components
Batteries: Car battery: l pc of 3.6V AA rechargeable battery Remote
controller battery: 2pcs of 1. SV AA batteries
Battery Installation
- Open the battery cover of the remote controller as Fig 2A showed, and inserts 2pcs of
- SY AA batteries and then screws the cover.
- Open the cover under the truck by a screwdriver, inserts the LPC of the 3.6V AA rechargeable battery as the correct polarity, and then screw the cover. (Fig 2B)
2.4G Auto Coding
- After installing the batteries of the truck and remote controller, open the remote controller switch. The light at the front end of the remote controller’s indicator will flicker slowly and then automatically code, meaning the automatic encoding succeeds.
- One remote controller only could code one car. After the success of coding, there is non-interference of each car.
- If the remote controller could not find out the 2.4G signal of the car in a minute, it would turn in a sleeping state(light off of the indicator). To press any key to activate.
- To remake a pair with other cars or remote controllers after turning off the power of both.
Basic Operation and Functions
- Forward/backward: To push the Left Trigger ahead/ back, the truck would go forward/backward. (Fig 4B
- Turn Left/Right: To push the Left Trigger forward/backward, and the Right Trigger turns left/right, the truck will turn left/right. (Fig 4C)
- Excavating: press the key of “Excavating” after starting the car, the car will make a motion.(Fig 40)
- Unloading: press the key of “Uoloading” after starting the car, excavator will make a motion. (Fig 40)
- Left/Right Rotation: press the key of “Left(or Right) Rotation”, excavator will do a motion of left (or right) rotation.(Fig 4E)
Auto-OFF : after starting the excavator, the car will automatically shut down without receiving any controlling signal in 60 seconds. then all the functions are at a status of standby.
Notice
- Don’t play with the toy on the road, select a safe place for operating to avoid danger.
- Plays the toy in water may cause short circuit damage. Please use a dry cloth to clean the car. Fig 4E
- If abnormal speed or reaction, it may be because of insufficient battery power, please charge the battery.
- The batteries should be charged under adult supervision. Please use the batteries recommended.
- Please install the battery in the correct polarity.
- Do not mix new and old batteries, short-circuited.
- Please charge the battery before initial use.
- Please check the plug case and other units of charger regularly to make sure that it is not broken. Don’t use it again if you find an abnormality in the charger.
- Please do not connect the product to different performance power
CHOKING HAZARD -small parts, not for children under 3 years
Specifications colors and contents may vary from illustrations
- Frequency bands: 2402MHz to 2480MHz
- Manufacturer: Double Eagle Industry (China) Limited.
- Address: Xingda Industrial Park, Chenghai
- District, Shantou City, Guangdong g Province, China.
- Importer: JAMARA e.K.
- Address: lnh. Manuel Natterer
FCC
Aichstetten Germany changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCCSDoC
Supplier’s Declaration of Conformity
- 47 CFR § 2.1077 Compliance Information
- Unique Identifier
- Trade Name: Double E
- Model No.: E571-003
- Responsible Party – U.S. Contact Information
MODIFICATION: Any changes or modifications not expressly approved by the
grantee of this device could void the user’s authority to operate the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation Hereby, [DOUBLEEAGLE
INDUSTRY (CHINA)LIMITED), declares that this [REMOTE CONTROL CAR SERIES]
complies with the essential requirements and other relevant provisions of
Directive 2014/53/EU.
The full text of the EU Declaration of conformity is available at the
following internet address: www.doublele-group.com
OPERATING FREQUENCY EIRP(MAX.)
2405MHz ~ 2475MHz-4.55dB
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>