REGIOLUX Stail Sax 6030 Surface Mounted Luminaires Instructions
- October 27, 2023
- REGIOLUX
Table of Contents
REGIOLUX Stail Sax 6030 Surface Mounted Luminaires
INSTALLATION
Safety Information
General Safety Information
- Mounting, commissioning, and maintenance only by a skilled electrician.
- Safety of the luminaire is only guaranteed in case of proper installation and maintenance and proper use according to intentions. In case of modification of the luminaire or improper use, there is mortal danger and fi re hazard due to electric shock or short circuit.
- Electrical connection must be carried out correctly and in accordance with all valid standards and other national and international safety and accident prevention regulations.
- Installation instructions must be stored and in any case read before using the luminaire.
- Loss of liability of manufacturer due to subsequent modifications to luminaires or their improper use.
- No liability due to damage from improper use.
- Use only original parts during repairs and maintenance.
- Only use lamps approved according to the identification plate.
- Ensure load capacity of the ceiling and mounting elements.
- Luminaire is only suitable for indoor applications and ambient temperatures of up to 25°C.
Luminaire operation
- With multi-lamp luminaire, align cool spots of lamps (= position of imprint) in one direction.
- With vertical wall mounting, align cool spots of lamps (= position of imprint) downwards.
- Specifications of the luminaire manufacturer must be observed.
- Carry out relamping immediately after end of service life.
- Eliminate overvoltage to electronic ballasts caused by e.g. unbalanced load.
- Do not deactivate lamps by rotating these in their sockets but switch off the luminaire.
- To avoid EMC problems, do not route through wiring directly along the luminaire wiring.
- Connect control inputs of dimmable luminaires with standard cables suitable for mains voltage.
Operation of the dimmable luminaire
- With lamps in dimmable luminaires, initially burn in at 100% 100h.
Changes to our products
Modification, reworking, and re-marking of products can have a negative impact
on their technical properties, destroy them and possibly cause consequential
damage to other objects. The manufacturer cannot be held responsible for
damage caused by such changes.
- d+ IP5x – dust nonconductive
- d+ IP6x – dust conductive and dust nonconductive
Regiolux GmbH
Hellinger Str. 3
D-97486 Königsberg/Bay.
T 09525 89-0
http://www.regiolux.de
[email protected]
Read User Manual Online (PDF format)
Loading......