REGIOLUX HLE-6052 LED Recessed Light Installation Guide

**REGIOLUX HLE-6052 LED Recessed Light

**

Assembly And Installation Instructions

UBD-74 7995 0742 100
UBD-122 7995 1222 100

WSPHL

28/54W – 79961200100
49/80W – 79961500100

Safety Information

General Safety Information

• Mounting, commissioning and maintenance only by a skilled electrician.
• Safety of the luminaire is only guaranteed in case of proper installation and maintenance and proper use according to intentions. In case of modification of the luminaire or improper use, there is mortal danger and fi re hazard due to electric shock or short circuit.
• Electrical connection must be carried out correctly and in accordance with all valid standards and other national and international safety and accident prevention regulations.
• Installation instructions must be stored and in any case read before using the luminaire.
• Loss of liability of manufacturer due to subsequent modifications to luminaires or their improper use.
• No liability due to damage from improper use.
• Use only original parts during repairs and maintenance.
• Only use lamps approved according to the identification plate.
• Ensure load capacity of ceiling and mounting elements.
• Luminaire only suitable for indoor applications and ambient temperature of up to 25°C.

Luminaire operation

• With multi-lamp luminaire, align cool spots of lamps (= position of imprint) in one direction.
• With vertical wall mounting, align cool spots of lamps (= position of imprint) downwards.
• Specifications of the luminaire manufacturer must be observed.
• Carry out relamping immediately after end of service life.
• Eliminate overvoltage to electronic ballasts caused by e.g. unbalanced load.
• Do not deactivate lamps by rotating these in their sockets but switch off luminaire.
• To avoid EMC problems, do not route through-wiring directly along luminaire wiring.
• Connect control inputs of dimmable luminaires with standard cables suitable for mains voltage.

Operation of dimmable luminaire

• With lamps in dimmable luminaires, initially burn in at 100% 100h.

Changes to our products

Modification, reworking, re-marking of products can have a negative impact on their technical properties, destroy them and possibly cause consequential damage to other objects. The manufacturer cannot be held responsible for damage caused by such changes.

+ IP5x – dust nonconductive
+ IP6x – dust conductive and dust nonconductive

Information for service, cleaning and disposal of luminaire

Instruction for luminaire service:

• Replace aged or failed lamp.

• Switch off, switch off supply to luminaire.

• Open luminair

• Remove old lamp send to recycling centre

• Insert the new lamp into lamp holder

• Refit optic

• Make funktional test

Instruction for luminaire cleaning:

• Replace aged or failed lamp

• Switch off, switch off supply to luminaire

• Clean outside luminaire

• Remove optic

• Clean inside luminaire

• Refit optic

• Make funktional test

Instruction for end of life and components disposal:

• Switch off, switch off supply to luminaire.

• Remove lamp for disposal

• Remove battery for disposal

• Remove luminair for disposal

• Dispatch materials to WEEE recycling plant

Customer Support

Safety instructions in your national language can be found on the Internet at: doc.regiolux.de/safety_BG.pdf

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>