Cj Global 538FWSC Fast Wireless Charging Stand User Manual
- June 6, 2024
- CJ GLOBAL
Table of Contents
Cj Global 538FWSC Fast Wireless Charging Stand
Brief introduction
- Wireless Charging Position
- Indication LED light
- Micro USB Input
- USB Output 1
- ) USB Output 2
Specification
- Wireless Charger Input: 5V/3A, 9V/2A
- Wireless Charger Output(Max): 10W (Compatible with 5W or 7.5W)
- Wireless Distance: 8mm
- Efficiency: ≥75%
- Dimensions: 1237594mm
- Weight: 116g
Use Operation
Charge other device
-
Use a suitable cable to connect the Wireless Charger Stand
Remarks : This wireless charger stand is suitable for 10W fast charge, need to connect to a Fast Charge power like 9V/2A -
Put a Smartphone which is with Qi wireless charge function on the wireless charger stand, make sure its position is at the middle right position
-
The 2 USB Ports can output to charge smartphones or another device as well.
FCC Statement
This device complies with part 15 and part 18 of the FCC Rules. Operation is Subject To the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not explicitly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 and part 18 of the FCC
Rules. These limits are designed to provider reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15 cm
surrounding the device and 20 cm above the top surface of the device must be
respected.
This device complies with Part 18 of the FCC Rules. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Increase the separation between the equipment and any other radio device.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.