CJ Global 23906 TWS 5.0 Bluetooth Earbuds User Manual

CJ Global 23906 TWS 5.0 Bluetooth Earbuds

QUIK CONNECTION GUIDE

Take out the left and right earphones from the charging compartment, the earphones will automatically turn on after a couple seconds.

•  The main earphone (R) will enter the pairing mode (flashing red and blue light).
• Both earbuds will sync with each other automatically.
•  Enter Bluetooth moi:le on your mobile device, search for “TWS Earbuds’; and select.
•  There will be a prompt stating, “Connected:’ This means both earphones are connected and synced up to your mobile device.

SAFETY INSTRUCTIONS

Please read these instructions carefully before operating this device. POWER SOURCE

•  Only use the power supply that came with the product. Using an unauthorized power supply will invalidate your guarantee and may irrecoverably damage the product.

MOISTURE AND WATER

•  Do not leave it in low temperatures as moisture can form inside the product, which may damage the circuit board.
•  Keep away from heat sources and flames
•  Do not leave it in high temperatures as electronic devices and plastic parts may warp in heat.

CAUTION

To avoid possible hearing damage, do not listen to music at high volume levels for long periods of time. Always keep the volume within reasonable limits.

GENERAL SAFETY INFORMATION

•  Keep the product and all its !)arts out of reach of small children .
•  This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowldge, unless they have ben given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

SPECIFICATIONS

• Dual mode Bluetooth 5.0,
• ultra-low power consumption
• Connection Distance: 10m
• Playback time: 3 hours
• TaiKING time: 3 hours
• Standby time: 300 hours
• Charging case: 9 hours of additional playback/talk Earpnone charge time: 1 hour
• Charging case charge time: 1 hour
• Earpnone battery capacity: 3.7 V 35mAh Charging case battery capacity: 300mAh

BLUETOOTH FUNCTIONALITY

1.  Answer calls: For an incoming call, press either left or right button to answer the call.
2.  End inn calls: While in a call, press either left or right button to end the call.
3.  Rejecting calls: For an incoming call, double press the left or right button to reject the call.
4.  Music plaYback: Press the main button on either earphone to play/pause music.
5.  Next/Previous song: To play the next song, press the right (R) earphone button twice: To play the previous song or restart the current song, press me left (L) earphone button twice.
6.  Intelligent Assistant: Press the right (R) earphone button three times to activate your phone’s intelligent assistant.

CHARGING CASE

There are two functions of the charging Case: charging and stor\ng the earphones.

1.  Charging: When the earphone’s batteries are low, place them into the charging case to begin charging. The red light on the main button of each earphone will be solld red. When the earphones are fully charged, the red lights on the earphones will shut off. The same light display will occur when charging the case itself if the earphones are in it.
2.  Storage: When the earphones are not used, case. place They th m inside_ the M is distributed by CJ Global Inc.
   carguing Wii Automat1cal)y All rights reserved. 201 Maple Ave Fair Lawn NJ 0741 o disconnect from your device and begin The Bluetooth• word mark and o logos are registered trademarks
   to charge. When taking them out of the owned by the BluetoothSIG. Inc. and any use of such marks by CJ Global case they will automatically reconnect is under. license. Other trademarks and trade names are those of their respected,ve owners. to your device.

FCC Statement

This device complies with par115 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference, received, including interference that may cause undesired operation,
Note: This equipment has been tested and found to comply with the limits for a Class B digital device.pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help,

Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user’s authority to operate the equipment. The device has been evaluated to meet general RF exposure requirements. To maintain compliance with FCC’s RF exposure guidelines, the distance must be at least 20 cm between the radiator and your body, and fully supported by the operating and installation configurations of the transmitter and its antenna(s),

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>