Polibi CB-2PLGLS-23 57.5 Inch and 79.9 Inch W Round Arm Linen Straight Sofas Instruction Manual
- June 5, 2024
- Polibi
Table of Contents
ASSEMBLY INSTRUCTIONS
CB-2PLGLS-23 57.5 Inch and 79.9 Inch W Round Arm Linen Straight Sofas
If you
have any questions about the product, please contact the email:
[email protected]
WARNING
- This product has been designed for seating two (2) average adults. To prevent injury and damage to this unit, PROHIBIT jumping on it.
- This product is designed for home use and not intended for commercial use.
- Children under the age of 5, small infants, and babies should not sleep alone on this product for safety reasons.
- Recommended # of people needed for handling: 2 (however it is always better to have an extra hand.)
- THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP IT FOR FUTURE REFERENCE.
PARTS
Step 1: Carefully unpack parts/hardware from the box and store of seat
body, place on a clean flat surface. 
Step 2: Place both arms as shown
below, and secure two legs into pre-drilled holes on the bottom of the arms.
Please avoid overtightening. 
Step 3 : Carefully lift and turn
assembled arms onto their legs. Insert seat body metal plates to both arms as
shown below.
Ensure it is correctly in place. 
Step 4: Insert backrest with
earpiece metal plates to both arms as shown below. Ensuring is correctly in
place. 
Step 5: Insert backrest metal plates to both arms as shown
below. Ensuring it is correctly in place.
Step 6: Finally, stretch
and pull down the rear cover evenly before securing the velcro strap to the
seat base. Repeat if necessary for a better fit.
ASSEMBLY INSTRUCTIONS
This product has been designed for seating three (3) average adults. To prevent injury and damage to this unit, PROHIBIT jumping on it.- This product is designed for home use and not intended for commercial use.
- Children under the age of 5, small infants, and babies should not sleep alone on this product for safety reasons.
- Recommended # of people needed for handling: 2 (however it is always better to have an extra hand.)
- THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP IT FOR FUTURE REFERENCE.
PARTS
Step 1: Carefully unpack parts/hardware from the box and store of seat
body, place on a clean flat surface.
Step 2: Place both arms as shown
below, and secure two legs into pre-drilled holes on the bottom of the arms.
Please avoid overtightening.
Step 3: Carefully lift and
turn assembled arms onto their legs. Insert seat body metal plates to both
arms as shown below.
Ensure it is correctly in place.
Step 4: Insert backrest with earpiece
metal plates to both arms as shown below. Ensuring is correctly in
place.
Step 5: Insert backrest metal plates to both arms as shown below. Ensuring
it is correctly in place.
Step 6: Finally, stretch and pull
down rear cover evenly before securing velcro strip to seat base. Repeat if
necessary for better fit.