CJ Global 24065-DI TWS True Wireless Magnetic Speakers User Manual
- June 5, 2024
- CJ GLOBAL
Table of Contents
CJ Global 24065-DI TWS True Wireless Magnetic Speakers
Charging the Speakers
Your speaker will work best if it is within 30ft of your smart device. You may experience sound briefly cutting off if you are Out of range or if your wireless connection is weak. If the speakers are not paired with a device after 5 minutes, they will turn off automatically. Make sure Bluetooth is enabled on your smartphone or tablet before starting the pairing process. True Wireless (TWS)& Bluetooth Pairing Turn on both speakers by long pressing (2 seconds) the Power Switch to the “ON” position. Both of the speakers will prompt when they are ready to connect to each other. Wait 3 seconds, the speakers will automatically pair to each other and one speaker will “‘prompt” to indicate it is paired with the second speaker. From your smartphone or tablet, find a list of nearby devices and choose “True Wireless Speaker”, and enter “0000” if asked. Ine speaker will prompt again when pairings are completed. The speakers can be paired to different devices. For example, you can use one speaker with a smartphone and the other speaker with a tablet Turn on one speaker by the long press (2 seconds) by flipping the Power Switch to the “ON” position. The first speaker Will prompt when it is ready to pair. Leave the second speaker to turn off. Pair one device at a time to your multiple devices. From your smartphone or tablet, find a list of nearby devices and choose “True Wireless Speaker”, and enter “0000” if asked. Ine speaker Will prompt again when pairing IS Completed. To pair the second speaker, repeat steps 1 and2 with your second device. Ensure that you are far enough away from the first speaker and device to avoid a signal error.
Warning
- Keep away from water and moisture.
- Keep away from heat sources.
- Do not disassemble.
Connection Lost?
- If pairing two speakers does not work, turn off the speakers and repeat the steps again “Using speakers as a pair”.
- Make sure your speakers are Within the range of your smart device
- if you hear a long prompt, you need to recharge your speakers, Connection may be lost due to low battery.
- When charging your speakers, only use the enclosed USB cables.
- The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc., and any use of such marks by CJ Global is used under license. Other trademarks and trade names are those of their respective owners.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction