PURe geaR 09292PG Pureboom Wireless Headphones User Manual
- June 6, 2024
- PURe geaR
Table of Contents
PURe geaR 09292PG Pureboom Wireless Headphones
Connecting / Bluetooth Pairing
-
Make sure the PureBoom Wireless Headphones are within 2-3 feet (0.6-0.9 meters) of the device you will be connecting to.
-
Press and hold POWER button for 4 seconds to enter pairing mode.
The LED light will rapidly flash blue and red when pairing. -
Select “PureGear Headphones” from the list of found devices.
-
When paired, the LED slowly flashes blue.
- If your device does not automatically detect your headphones, make sure Bluetooth is turned on, do a SEARCH for “PureGear Headphones” and then click CONNECT.
Operating PureBoom Wireless Headphones
| To… | Button | Press |
|---|---|---|
| Turn on/off headphones | and hold 4 seconds | |
| Start Bluetooth pairing | With headphones turned off, press and hold until led |
flashes red and blue
Play/Pause music| Short press once
Volume up/down| | Short press once
Skip or repeat song| Long press once
Answer/end call| | Short press once
Reject an incoming call| Long press once
Features and Specifications
Frequency response: 20Hz-20kHz
Charging Input: DC 5V
Li-ion battery size: 200mAh
Driver size: 40mm
Impedance: 32Ω±10%Ω
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
FCC ID: 2AIIF-09292PG
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>