pure-gear PureBoom Orbs Wireless Earbuds User Manual
- June 6, 2024
- PURe geaR
Table of Contents
Orbs Wireless Earbuds
User Manual
Connecting/Bluetooth Pairing
- Make sure the PureBoom Orbs Wireless Earbuds are within 2-3 feet (.6-.9 meters) of the device you will be connecting to.
- Remove battery saver sticker from each of the earbuds to activate.
- Remove both earbuds from the charging case and place them into your ears.
- Turn on your device’s Bluetooth. Most devices will automatically detect your earbuds. Locate andselect “ PureBoom Orbs ”. It will indicate that your earbuds are now connected or paired.
- If your device does not automatically detect your earbuds, make sure Bluetooth is turned on, do a SEARCH for “PureBoom Orbs” and then click CONNECT.
Notes: To shut down, press the Earbuds for 4 seconds or place them back into the charging case. Once paired, the range is approximately 32 feet/10 meters. Your PureBoom Orbs Wireless Earbuds will automatically connect to the last paired and connected device when it is turned on again.
Operating PureBoom Orbs Wireless Earbuds
When playing music:
- To skip to the next song, tap and hold the right earbud for about 1.5 seconds.
- To repeat the previous song, tap and hold the left earbud for about 1.5 seconds.
- To pause/play, double-tap the right or left earbud. When on a call:
- To answer or hang up a call, double-tap the right or left ear button.
- To increase volume, tap the right ear button.
- To decrease volume, tap the left ear button.
- To reject an incoming call, press and hold right or left earbud for 2-3 seconds.
Features and Specifications
Frequency response: 20Hz-20kHz
Charging Output: DC5V 100mA
Li-ion battery size: charging case
902030 500mAh; Earphone
501012 40mAh
Driver size: 6mm
Impedance: 16 Ω± 15 %
FCC Statement
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
FCC ID: 2AIIF-09347PG
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>