PURe geaR 09346PG PureBoom Wireless Earbuds User Manual
- June 6, 2024
- PURe geaR
Table of Contents
User Manual
Guide utilization
Manual del usuario
Connecting / Bluetooth Pairing
1. Make sure the PureBoom Wireless Earbuds are within 2-3 feet (.6-.9 meters)
of the device you will be connecting to.
2. Press the MFB Button for 5 seconds to go into pairing mode.
3. Turn on your device’s Bluetooth. Most devices will automatically detect
your earbuds. Locate and select “ PureGear PureBoom ”.
It will indicate that your earbuds are now connected or paired.
- If your device does not automatically detect your earbuds, make sure Bluetooth is turned on, do a SEARCH for “ PureGear PureBoom ” and then click CONNECT.
Notes:
To shut down, press the MFB for 3 seconds. Once paired, the range is
approximately 32 feet/10 meters. Your PureBoom Wireless Earbuds will
automatically connect to the last
paired and connected device when it is turned on again.
Operating PureBoom Wireless Earbuds
When playing music:
- To skip to the next song, press the + button for 2-3 seconds.
- To restart the current song, press the – button for 2-3 seconds.
- To Pause/Play, press the MFB.
When on a call:
- To answer a call, press the MFB.
- To hang up a call, press the MFB.
- To increase volume, press the + button.
- To decrease volume, press the – button.
- To reject an incoming call, press the MFB for 2-3 seconds.
Features and Specifications
Frequency response: 20Hz-20kHz Charging Output: DC5V 100mA Li-ion battery size: 80mAh Driver size: Ø10mm Impedance: 16±15%Ω
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
FCC ID: 2AIIF-09346PG
pure-gear.com
©2021 | F00175PG | 09346PG
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>