PURe geaR 63900PG 15W Fast Magnetic Wireless Charging Pad User Manual
- June 9, 2024
- PURe geaR
Table of Contents
63900PG 15W Fast Magnetic Wireless Charging Pad
User Manual
Fast Magnetic
Wireless Charging Pad
Specs
-
Input: 5VDC/3A; 9VDC/2.22A; 12VDC/1.67A
-
Output: Up to 15W (Fast Charge)
-
Charging time may vary based on device
NOTE: A 20W or higher USB-C™ Power Adapter is recommended (sold separately) to enable fast wireless charging.
Caution
DO NOT place any credit cards or other types of magnetic material near the charging pad. Do not attempt to disassemble the wireless charging pad as it may short circuit or damage the product. Keep at least 8” (20cm) distance between implantable medical devices such as pacemakers, cochlear implants, etc. Keep this product in a dry and ventilated space. Do not place in direct heat or use in high humidity environments. Do not use organic solvents to clean surface.
Using your Fast Magnetic Wireless Charger**- Plug the USB-C connector into the wall charger (not included).
- Plug in the wall charger (20W PD charger recommended).
- Place the PureGear Magnetic Wireless Charger onto the back of your MagSafe® device until it automatically aligns and snaps into place.
-
NOTE: Works with MagSafe cases. Non-MagSafe cases must be removed before charging.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 8 inches between the radiator & your body.
FCC Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy; if not
installed and used in accordance with the instructions, maybe cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different form that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) thatcomply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Lifetime Warranty
This product is fully warranted against defects in materials and workmanship for the lifetime of the product, so long as the manufacturer continues to make this product. If a product fails due to a manufacturing defect, we will replace it upon proper proof of purchase by the original purchaser. Replacement product will be subject to shipping and handling charges. Damages through normal wear and tear, alteration, misuse, neglect, accident, service by anyone other than the authorized service center, or act of God, are not covered by this warranty. For all warranty claims, the product must be returned in accordance with PureGear’s return policy. All trademarks and trade names are used for reference purposes only and are the property of their respective owners.
pure-gear.com
© 2023 F00190PG
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>