Orange Tech Innovation 05355 Projection Screen Remote Controlmote Control Instructions

June 5, 2024
Orange Tech Innovation

TJ7500CK
C0ntrol remote control electric curtain motor
Instructions
**please read this instruction before you use the remote controller

**

 Product features

  1.  Imported chip, advanced technology, reasonable design, beautiful appearance, overpressure protection and lightning protection design, safe and reliable.
  2. Long-distance radiofrequency emission design, unobstructed by obstacles, simple and convenient operation.
  3. This remote receiver is an intelligent learning type, which can easily set up multiple remote control handles.

Scope of application

This product is used for voltage AC85 — 265 V(other specifications can be customized) AC motor positive, stop , reverse control, such as electric screen, curtain, shade, electric remote control door.

Technical indicators

  1. Rated voltage: AC85 — 265 V
  2. Load power: 500W
  3. Operating frequency: 315 MHz
  4. Control current: 3A
  5. Remote control distance: not less than 50 meters(open space)

Installation and use

  1. When installing, please check the voltage before the power is off, in case of electric shock. The wiring can be installed as shown in the receiver panel.
  2. Pay attention to the connector not to be exposed and avoid the short circuit.

Precautions

  1. Do not install the receiver in hot and humid places.
  2. If the motor is not working after installation, it should be confirmed whether the centerline is connected correctly. If not, please consult the supplier.
  3. After installation, the motor is not running in the right direction. Please exchange the ascending and descending wires.
  4. Please replace the remote control battery (23V12A) if the remote control is shortened or not remotely controlled.

Warranty conditions

The product will be free of charge for three years if the non-person is damaged or improperly installed.

Learning and cleaning remote control

1.1earn| When the controller needs to pair the new remote control| In the standby state (red light, the motor does not turn) press the Stop Button for 3 seconds, red light off, immediately press any key of the remote control, red light flashing often bright, learning success, then the remote control can be used
---|---|---
2. Clear code code| Clear all remote code values in the controller| In standby(red light, the motor does not rotate) press the stop button,(hold down) after the red light goes oft about 5 seconds, the red
light flashes Changliang, when all the remote controls will not be used. Note: After the controller is cleared, it will enter the learning mo de directly again. There will be no learning such cess within 5-10 seconds and it will exit directly.

FCC Warning

Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
    This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals