pure gear 09514PG Fast Wireless Charger User Manual
- June 5, 2024
- PURe geaR
Table of Contents
pure gear 09514PG Fast Wireless Charger
Specs
- Input: 5VDC/3A; 9VDC/2.22A; 12VDC/1.67A
- Output: Up to 15W (Fast Charge)
Charging time may vary based on device
NOTE: 20W USB-C Power Adapter is required (not included) to enable fast
wireless charging.
Caution
DO NOT place any credit cards or other types of magnetic material near the
charging pad. Do not attempt to disassemble the wireless charging pad as it
may short circuit or damage the product. Keep at least 8” (10cm) distance
between implantable medical devices such as pacemakers, cochlear implants,
etc. Keep this product in a dry and ventilated space. Do not place in direct
heat or use in high humidity environments. Do not use organic solvents to
clean surface.
Using your Fast Wireless Charger
- Plug the USB-C connector into the wall charger. (USB-C wall charger not included.)
- Plug in the wall charger.
- Place the PureGear Magnetic Wireless Charging Pad onto the back of your Qi-enabled device until it automatically aligns and the LED light comes on. Note: The LED light will turn off after 30 seconds.
NOTES:
- The white LED light will flash when interference is detected, or an object is in the way of the charger.
- This Magnetic Wireless Charging Pad also supports non-magnetic devices.
One Year Limited Warranty
This wireless product is covered by a limited warranty to the original purchaser only in that this product is free from defects in workmanship and materials for ONE-YEAR from the date of purchase (damages through normal wear and tear, alteration, misuse, neglect, accident, service by anyone other than the authorized service center, or act of God not included). During the warranty period and with proper proof of purchase, this wireless product will be replaced. This limited warranty is in lieu of all other warranties, express or implied, including, but not limited to, implied warranty of merchantability or fitness for a particular use. For all warranty claims, the product must be returned in accordance with PureGear’s return policy. All trademarks and trade names are used for reference purposes only and are the property of their respective owners.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance of 8 inches between the radiator & your body.
FCC Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, maybe cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
IC Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 10cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>