KODAK ROCPGTRM070 Photo Gear Tripod User Guide
- June 6, 2024
- Kodak
Table of Contents
KODAK PHOTO GEAR
TRIPOD + MONOPOD
70″ / 178 cm
User Guide
TO SEE THIS GUIDE IN FRENCH, ITALIAN,
GERMAN, OR SPANISH, PLEASE VISIT
WWW.KODAKPHOTOPLUS.COM
OR USE THIS QR CODE:
https://www.kodakphotoplus.com/pages/tripod-monopod-70-178-cm-support
INTRODUCTION
Thank you for purchasing the KODAK 70″ / 177 cm 2-in-1 Tripod + Monopod. This
User Guide is intended to provide you with guidelines to ensure that the
operation of this product is safe and does not pose risk to the user. Any use
that does not conform to the guidelines described in this User Guide may void
the limited warranty.
Please read all directions before using the product and retain this guide for
reference. This product is covered by a limited one-year warranty. Coverage is
subject to limits and exclusions. See warranty for details.
SAFETY PRECAUTIONS
- WARNING: CHOKING HAZARD-Small parts. This product contains small parts and is not suitable for children under 3 years old.
- Remove all packaging before using this device. Please keep all packaging materials out of reach of children and pets.
- Properly dispose of all packing materials immediately after unpacking the product, as the bags used for packaging could present a suffocation or choking hazard.
- Read all instructions carefully before attempting to operate this device. Improper usage could result in a reduction in efficacy.
- Please take care when extending and folding this unit to avoid damage through rough handling.
- Ensure that all knobs, latches, and levers are in their fully locked positions before using this unit with a camera.
- Do not attempt to move this unit while the camera is attached. First, take the camera off, then move the unit before replacing the camera.
- Do not attempt to oil or lubricate any of the parts of the tripod. Doing so may cause damage and void the warranty.
- Do not store this unit in environments with high temperatures.
- Do not use it during lightning storms.
- Do not sit or ride on the tripod or allow others to do so, as this may cause injuries as well as damage to the product.
- Do not use harsh chemicals for cleaning this product; use only a mild detergent and soft cloth, and dry well before storing.
PACKAGE CONTENTS
- 70″ / 177 cm 2-in-1 Tripod + Monopod
- 2 Quick-Release Plates
- Smartphone Adapter
- 1/4″ to 3/8″ (0.6 cm to 0.95 cm) Screw Adapter
- Carry Case
- Access to free KODAK Tripod/Monopod E-Guide
- User Guide
SCAN THE QR CODE BELOW WITH
YOUR SMARTPHONE TO DOWNLOAD THE
FREE KODAK TRIPOD/MONOPOD E-GUIDE!
https://www.kodakphotoplus.com/pages/tripod-usage-guide
ABOUT THE KODAK 70″ / 178 CM TRIPOD + MONOPOD
- Unique 2-in-1 design delivers a tripod with an integrated monopod
- Tripod + Monopod has fully adjustable 4-section legs, removable Center Column converts to a 5-section monopod, and a 3-way swivel pan head is included.
- Two (2) quick-release plates are included that allow you to switch cameras without the need to unscrew the plate.
- 1/4 ” to 3/8″ (0.6 cm to 0.95 cm) screw adapter
- 3-way head allows camera to tilt and pan freely to capture stunning images
- Telescoping, fliplock leg system allows for a wide range of heights
- Sturdy yet lightweight ABS and aluminum construction keeps your camera secure
- Rubberized swivel feet keep the tripod safely in place
- Folding center column handle
- Locking aluminum center spreader for maximum stability
PRODUCT OVERVIEW
- Quick-release lever
- Monopod
- Monopod locking knob
- Foam grip
- Hook
- Center brace locking ring
- Rubber foot
- Leg locks
- Folding center column handle
- Swivel pan head handle
- Camera mount platform tilt knob
- Vertical tilt locking handle
- Horizontal pan locking knob
- Quick-release plate
- Mounting screw
PRODUCT OVERVIEW (CONTINUED)
-
Adjustable Legs
a. Unlatch the leg locks at the bottom of the leg.
b. Pull out the sections of the leg until it reaches your desired length.
c. Use the center brace locking ring to adjust the center portion of the tripod up and down to maximize stability.
d. Use the built-in level to ensure the tripod is positioned properly.
e. Re-latch the locks once you have the legs configured as you wish. -
Center Column/Removable Monopod
a. Loosen the center column locking knob to adjust the height or remove the monopod for separate use.
b. If adjusting tripod height, pull out until you reach your desired length (never pulling past the “Stop Here” mark).
c. Tighten the center column locking knob to secure it in place.
d. The removable monopod provides a lightweight, portable option for extra versatility.
e. To adjust the central column/monopod:
i. Hold the central column/monopod in one hand and grasp the bottom with the
other.
ii. Turn the bottom a quarter-turn to the left and extend the section. The
full column may extend all at once, in which case you can
skip step iii and proceed to step iv.
iii. To increase the length, twist the extended section another quarter-turn
to the left and pull the next section out. Repeat this process until the
monopod is extended to the necessary height.
iv. Turn any extended section to the right to securely lock it into position.
You can lock a section into place at any length; it does not need to be fully
extended to lock.
v. To collapse, reverse the process by turning each section to the left to
unlock it and then pushing in until the unit is fully collapsed.
- 3-Way Swivel Pan Head
a. 1-Way – To adjust the vertical tilt of the camera mount plate:
i. Loosen the vertical tilt handle.
ii. Adjust to the desired angle.
iii. Tighten the vertical tilt handle.
b. 2-Way – To adjust the horizontal pan of the camera mount plate:
i. Loosen the horizontal pan knob.
ii. Pan right and left to the desired position.
iii. Tighten the horizontal pan knob.
c. 3-Way – To adjust the tilt of the camera mount platform:
i. Loosen the camera mount platform tilt knob.
ii. Adjust the platform to the desired angle.
iii. Tighten the camera mount platform tilt knob.
-
Mounting a Camera
a. Pull the quick-release lever on the side of the head to release the plate.
b. Align the screw adapter with the corresponding threading on your camera.
c. Holding the camera in one hand, rotate the plate to the right until it is securely attached to the camera.
d. Place the camera mount plate back into position.
e. Push the quick-release lever back into the locked position.
f. To remove your camera:
i. Remove the quick-release plate.
ii. Unscrew the plate from the camera. -
Hook
a. To increase the tripod’s stability, you can hang a sandbag or similar weight from the hook. -
Mounting a Smartphone
a. Align the screw adapter with the corresponding threading on the smartphone adapter.
b. Holding the smartphone adapter in one hand, turn the thumbwheel to the right until it is securely attached to the adapter.
c. You may now pull up on the smartphone adapter clamp and insert your smartphone in landscape mode.
d. To remove the smartphone adapter, hold it in one hand and turn the thumbwheel to the left until it is no longer attached.
TECHNICAL SPECIFICATIONS
TRIPOD
Materials: Aluminum / ABS
Maximum Height: 70″ (177.8 cm)
Minimum Height: 21.5″ (54.6 cm)
Folded Length: 22″ (55.9 cm)
Weight Capacity: 8.8 lbs. (4 kg)
Tripod/Monopod Weight: 3.7 lbs. (1.7 kg)
MONOPOD
Materials: Aluminum / ABS
Maximum Height: 64.5″ (163.8 cm)
Minimum Height: 17.5 ” (44.5 cm)
Folded Length: 17.75 ” (45.1 cm)
Weight Capacity: 8.8 lbs. (4 kg)
Tripod/Monopod Weight: 1.0 lbs (0.45 kg)
WARRANTY INFORMATION
LIMITED WARRANTY ON KODAK 70″ / 178 cm 2-IN-1 TRIPOD + MONOPOD THIS LIMITED
WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS,
WHICH VARY FROM STATE TO STATE. WE WARRANT THAT DURING THE WARRANTY PERIOD,
THE PRODUCT WILL BE FREE FROM DEFECTS IN MATERIALS AND WORKMANSHIP.
LIMITATION OF LIABILITY
TO THE EXTENT NOT PROHIBITED BY LAW, THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF
ALL OTHER WARRANTIES, ORAL, WRITTEN, STATUTORY, EXPRESS, OR IMPLIED. EXCEPT
FOR THE EXPRESS WARRANTIES CONTAINED IN THIS LIMITED WARRANTY STATEMENT AND TO
THE EXTENT NOT PROHIBITED BY LAW, WE DISCLAIM ALL OTHER WARRANTIES, EXPRESSED
OR IMPLIED, STATUTORY OR OTHERWISE, INCLUDING WITHOUT LIMITATION, THE
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SOME
STATES DO NOT ALLOW DISCLAIMERS OF IMPLIED WARRANTIES, SO THIS DISCLAIMER MAY
NOT APPLY TO YOU. TO THE EXTENT SUCH WARRANTIES CAN NOT BE DISCLAIMED UNDER
THE LAWS OF YOUR JURISDICTION, WE LIMIT THE DURATION AND REMEDIES OF SUCH
WARRANTIES TO THE DURATION OF THIS EXPRESS LIMITED WARRANTY.
OUR RESPONSIBILITY FOR DEFECTIVE GOODS IS LIMITED TO REPAIR, REPLACEMENT OR
REFUND AS DESCRIBED BELOW IN THIS WARRANTY STATEMENT.
WHO MAY USE THIS WARRANTY? C&A Marketing, Inc. located at 114 Tived Lane
East, Edison, NJ (“we”) extend this limited warranty only to the consumer who
originally purchased the product (“you”). It does not extend to any subsequent
owner or other transferees of the product.
WHAT DOES THIS WARRANTY COVER? This limited warranty covers defects in
materials and workmanship of the KODAK 70″ / 178 cm 2-in-1 Tripod + Monopod
(the “product”) for the Warranty Period as defined below.
WHAT DOES THIS WARRANTY NOT COVER? This limited warranty does not cover
any damage due to: (a) transportation; (b) storage; (c) improper use; (d)
failure to follow the product instructions or to perform any preventive
maintenance; (e) modifications; (f) unauthorized repair; (g) normal wear and
tear; or (h) external causes such as accidents, abuse, or other actions or
events beyond our reasonable control.
WHAT IS THE PERIOD OF COVERAGE? This limited warranty starts on the date
of your purchase and lasts for one year (the “Warranty Period”). The Warranty
Period is not extended if we repair or replace the product. We may change the
availability of this limited warranty at our discretion, but any changes will
not be retroactive.
WHAT ARE YOUR REMEDIES UNDER THIS WARRANTY? With respect to any defective
product during the Warranty Period, we will, at our sole discretion, either:
(a) repair or replace such product (or the defective part) free of charge or
(b) refund the purchase price of such product if an exchange unit cannot be
provided.
HOW DO YOU OBTAIN WARRANTY SERVICE? To obtain warranty service, you must
contact us at 844-516-1539 or by
email at kodak@camarketing.com during the
Warranty Period to obtain a Defective Merchandise Authorization (“DMA”)
number. No warranty service will be provided without a DMA number and return
shipping costs to our facilities shall be assumed by you, the purchaser.
Shipping costs of the replacement unit to you shall be assumed by us.
GET IN TOUCH
Should you experience any problems with your product, please contact us before
returning the item to the place of purchase. We’re here to help!
U.S. Support:
kodak@camarketing.com
844-516-1539
International Support:
kodakintl@camarketing.com
844-516-1540
The Kodak trademark, logo, and trade dress are used under license from Eastman
Kodak Company.
All other products, brand names, company names, and logos are trademarks of
their respective owners, used merely to identify their respective products,
and are not meant to connote any sponsorship, endorsement, or approval.
Distributed by C&A Marketing, Inc., 114 Tived Lane East, Edison, NJ 08837 USA.
C+A Marketing c/o Partners in Logistics, 102 Shannon Free Zone, Shannon, Co.
Clare V14 PH21, Ireland
© 2020. C&A IP Holdings, LLC. All Rights Reserved. Made in China.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>