MICRO CONTROL SYSTEMS HANBELL RC2 SERIES Oil Pin Compressor Instruction Manual
- June 13, 2024
- MICRO CONTROL SYSTEMS
Table of Contents
**MICRO CONTROL SYSTEMS HANBELL RC2 SERIES Oil Pin Compressor Instruction Manual
**
INSTRUCTION
| Part # | Description | O-Ring | Compressor Model |
|---|---|---|---|
| 3101-1169A | 18mm Stop Pin | 4201-VA119 | RC2-170, RC2-200~580, RC2-620 |
| 3107-1169A | 24mm Stop Pin | 4201-VA122 | RC2-610, RC2-710~RC2-930 |
| 4304-105 | Connector – 1/2”NPT x 5/8”Flare |
The oil will be directed out of the compressor through the oil in and out connection by inserting the pin into the circulation line.
To complete this, follow these instructions:
- Remove the plug.
- Insert the pin for the compressor model as shown above.
- Replace the O-Ring for compressor model as shown above.
- Reinsert the plug.
- Tighten the plug.
Any questions regarding this release, contact:support@mcscontrols.com
Micro Control Systems, Inc. 5580 Enterprise Parkway Fort Myers, Florida 33905
239-694-0089 FAX:
239-694-0031
www.mcscontrols.com
Information contained in this document has been prepared by Micro Control
Systems, Inc. and is copyright © protected 2023.
Copying or distributing this document is prohibited unless expressly approved
by MCS.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>