KODAK E1000-S2000 Stacking Deflector Instructions

: June 3, 2024
: Kodak

Table of Contents

KODAK E1000-S2000 Stacking Deflector
Contents of the kit
How to install
How to use
Normal jobs
Expected use of tilt-stand legs
Documents / Resources

KODAK-E1000-S2000-Stacking-Deflector-LOOG

KODAK E1000-S2000 Stacking Deflector

KODAK-E1000-S2000-Stacking-Deflector-PRODUCT

Translation of these instructions is available at the on-line support page for your scanner model, for instance:

Contents of the kit

This kit contains:

One Stacking Deflector Accessory for the E1000, E1030, E1040, S2000 and S2000w model scanners.
Two Tilt Stand Legs for the E1000, E1030, E1040, S2000 and S2000w model scanners.

Expected use of stacking deflector
The stacking deflector accessory attaches to the front lower edge of the scanner cover. It helps paper exiting the scanner to remain in order and to stack correctly.

How to install

Turn the locking knob to vertical.
Hold the stacking deflector slightly in front of and lower than the front lower edge of the scanner cover, with the legs pointing away from the scanner.
The deflector bracket has four tabs. These tabs need to line up with four slots in the lower edge of the scanner cover.
When the tabs are lined up, squeeze on the small touch points to left and right of the locking knob. Squeeze, and then push the four tabs into the slots. Stop squeezing once the stacking deflector is seated against the lower edge of the scanner cover.
Turn the locking knob horizontally into its locked position. The stacking deflector is now held in place on the scanner. When the deflector is installed correctly, it will touch the partially extended output tray.

How to use

Scanning paper of mixed lengths

The stacking deflector legs are down for use.
The leg length is adjustable. Hold the stacking deflector at the touch points on the central hub when you want to change their length. Always adjust the legs to the same length before scanning.
When scanning pages of different lengths (such as a form accompanied by a check), adjust the stacking deflector accessory legs so they will trap the shorter page. The longer pages will push under the deflector legs, but shorter pages will stay close to the scanner.
If scanning pages of several different lengths (for example 3 inches, 5 inches, and 11 inches long), adjust the deflector legs so they will trap all the shorter pages. In this example, adjust to trap the 5 inch pages. The shorter pages will stay near the scanner, and the longer pages will push beyond the stacking deflector legs.

Normal jobs

If your jobs stack nicely without the stacking deflector accessory, you can flip it up so the stacking deflector rests on the scanner cover.

Flip the stacking deflector down again when needed. The stacking deflector is not recommended for lightweight pages longer than 150 mm (5.9 inches).

Expected use of tilt-stand legs

The tilt stand legs attach to the underside of the scanner. When extended, they enable raising the front edge of the scanner which assists the output of long pages.
How to install

Turn the scanner upside down, and grasp one tilt stand leg with the foot pad facing the rear of the scanner.
Tilt the leg slightly and insert it into one of the slots on the underside of the scanner. Align one of the pins on the side of the tilt stand leg with one of the openings at the front edge of the slot, and twist it into place.
Repeat for the other leg.

A-62003 5 October 2022

Documents / Resources

| KODAK E1000-S2000 Stacking Deflector [pdf] Instructions
E1000-S2000 Stacking Deflector, Stacking Deflector, E1000-S2000 Deflector, Deflector, E1000-S2000
---|---