CONRAD 989-383 Radio Control Vehicle Instruction Manual
- June 6, 2024
- CONRAD
Table of Contents
ITEM NO.: 989-383
INSTRUCTION MANUAL
THANK YOU VERY MUCH FOR YOUR PURCHASE OF THE COMPANY’S PRODUCT – AMPHIBIOUS CRAFT BEFORE USING THIS PRODUCT, PLEASE READ THE INSTRUCTION MANUAL CAREFULLY 80 THAT IT CAN BE USED CORRECTLY AND SAFELY. PLEASE BE SURE TO KEEP THE INSTRUCTION MANUAL FOR REFERENCE.
NOTE:
- The new Lithium battery pack included in this set needs to be charged before use.
- Plug the charger to a wall outlet and join the battery’s connector and the charger’s connector.
- Please charge for at least 8 hours for the first 2 times. Then, it’s enough to charge for 4 hours during normal use. Do not overcharge as it will not fill the battery with more power.
- Please check on a regular basis the wire, plug, and other electric parts on the toy, batteries, and charger.If any damage is found, please repair it before use.
SPECIFICATION AND PERFORMANCE
- FULL FUNCTION.GO FORWARD. BACK OFF, TURN LEFT.RIGHT. STOP,
- FREQUENCY BAND . 2.4GHz
- BATTERIES: USE 7.4V RECHARGEAGLE BATTERIES USE 2 X1.5V”AA”BATTERIES FOR REMOTE CONTROL
- R/C DISTANCE: 30-400
COMPONENT CONTENT AND FEATURE
1. BATTERY BIN
2. BATTERY COVER| 3. ON/OFF
4. DOUBLE STRENGTH SPIRAL
---|---
R/C FUNCTION
POWER SUPPLY SOCKET/BATTERY
OPERATION METHOD
PLEASE READ THE INSTRUCTION
- THE TRANSMITTER CAN CONTROL THE AMPHIBIOUS CRAFT TO 8 DIFFERENT DIRECTIONS.
BASIC DRIVING
TWIN MOTORS HELP PROPEL THE CRAFT ACROSS DIFFERENT TERRAIN. THE HOVERCRAFT
CAN ONLY WALK SIDE BY SIDE BUT NOT FORWARD IF SURFACES ARE TOO SMOOTH, AS
THERE IS NOT ENOUGH FRICTION.
SPECIAL STUNT ON WATER
IT CAN ROTATE 360 DEGREES ON WATER. WHICH IS A SPECIAL SKILL ON THE WATER ONLY.
BATTERY INSTALLATION AND CHARGE
AMPHIBIOUS CARFT
- UNSCREW THE SCREW FROM BATTERY COMPARTMENT WITH SCREWDRIVER, THEN OPEN THE BATTERY COVER.
- CONNECT THE USB CHARGER AND THE BATTERY, AND THE USB CHARGER CABLE NEEDS 5V POWER SOURCE.
- AFTER FULLY CHARGED, DISCONNECT THE POWER SUPPLY AND THE BATTERY. REPLACE THE BATTERY IN THE PRODUCT, CLOSE THE COMPARTMENT COVER AND SECURE IT IN PLACE WITH THE SCREW THAT YOU REMOVED BEFORE.
TIPS: PLEASE MAKE SURE THAT THE BATTERY RUNS OUT TOTALLY BEFORE
RECHARGING FOR THE FIRST 2 TIMES.
THIS COULD EXTEND THE BATTERY LIFE AND ENHANCE THE BATTERY PERFORMANCE.
R/C
- UNSCREW THE SCREW WITH THE SCREWORIVER ON THE BATTERY COVER (FIGURE 1);
- INSERT 2 X 1.5V AA BATTERY IN CORRECT POLARITY (FIGURE 2);
- COVER THE BATTERY COVER AND SCREW ON THE SCREW WITH A CROSS SCREWDRIVER (FIGURE 3):
TIP
-
WHEN THE POWER OF BATTERY |S INSUFFICIENT, IT WILL LOSE SOME FEAURES OR PERFORMANCE, PLEASE RE-CHARGE.
-
TRAVEL TIME DEPENDS ON DRIVING SURFACES AND ENVIRONMENT.
-
RADIO INTERFERENCE WILL REDUCE THE PERFORMANCE OF THE PRODUCT. PLEASE STAY AWAY FROM OTHER LARGE RADIO TOOL EQUIPMENT.
-
DO NOT BEND AND BREAK THE ANTENNA, THIS WILL AFFECT THE REMORE CONTROL DISTANCE, MAY GET OUT OF CONTROL.
-
DO NOT PUT THE CRAFT IN HIGH TEMPERATURE OR DIRECT SUNLIGHT. MAKE SURE THAT THE SWITCH IS CLOSED AND THE BATTERY IS TOOK OUT FROM THE BODY AND STORED IN A COOL USE.
-
USE A PIECE OF SOFT AND DRY CLOTH TO CLEAN THE HOVERCRAFT AFTER EVERY USE.
-
CONTROL THE HOVERCRAFT IN THE CLEAR CALM WATER. THE BEST CHOICE IS A PUDDLE OR A SHALLOW POND.
DO NOT OPERATED THE HOVERCRAFT IN SALT WATER. -
AFTER A WHILE IN THE WATER, YOU TO PAY ATTENTION TO THE POSITION OF THE HOVERCRAFT. MAKE SURE
THAT THE HOVERCRAFT IS CLOSED TO YOU, AND THEN YOU COULD REPLACE THE BATTERY WHEN IT IS POWER OFF -
DO NOT PLACE THE REMOTE CONTROL IN THE WATER. PLEASE TAKE OUT THE BATTERY IMMEDIATELY IF THE REMOTE CONTROLLER IS DROPPED INTO THE WATER ACCIDENTALLY. PUT THE REMORE CONTROL DEVICE UNDER DRY ATMOSPHERE. INSTALL A NEW BATTERY AND THEN RE-OPERATE.
ABOUT FREQUENCY AND FIELD
- THE REMORE CONTROL MAY NOT CONNECT SUCCESSFULLY IF THERE ARE HOVERCRAFT WITH THE SAME FREQUENCY IN THE OPERATION AREA.
- THIS PRODUCT IS SUITABLE FOR DRIVING IN A CLEAR CALM WATER, THE BEST CHOICE OF APUDOLE OR A SHALLOW POND.
WARNING:
CHOKING HAZARD -Small parts.
“Not for children under3smonths
The toys only to be connected to Class II equipment bearing the following symbol.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>