Altronix 6030 Multi-Purpose Timer Instruction Manual
- June 4, 2024
- Altronix
Table of Contents
6030
Multi-Purpose Timer
Overview:
Altronix 6030 programmable timer is suitable for most functions that require a timed operation e.g. Applications, Siren/Bell Cut Off Module, Dialer Delay, Guard Tour Supervisory Timer, Pulser / Flasher, etc.
Specifications:
Input:
• 6VDC or 12VDC operation is selectable.
Relay:
• Form “C” relay contacts are 8A at 120VAC/28VDC.
• Current draw stand by 3mA relay energizes at 75mA.
• Relay activates at the end of the timing cycle.
Features:
• Quick and extremely accurate time range adjustment from 1 second to 60
minutes.
• Repeat (flasher/pulse) mode.
Visual Indicators:
• LED indicates relay is energized.
Mechanical:
Board Dimensions (L x W x H approx.):
Installation Instructions:
- Select operation 6VDC (ON) or 12VDC (OFF) using DIP switch marked [SW1].
- Timing begins when power is applied.
- Relay energizes at the end of timing cycle.
- Desired settings are easily and accurately obtained by alignment of arrow on the potentiometer (top left-hand corner) on the board.
- Two-timing ranges, 1-60 seconds or 1-60 minutes are selectable with DIP switch marked [SW2] (OFF for minutes / ON for seconds).
- Latched (ON) LED indicates that timing cycle has ended and relay is energized.
- Board resets when power is removed or it can be reset with the application of momentary closure from terminal marked [+] to terminal marked [TRG].
- Cutting the repeat jumper (zero Ohm resistor located immediately to the right of the potentiometer) will cause the relay to cycle on and off at equal intervals. The timer will be in the pulser / flasher mode of operation.
Wiring Diagram for
Delayed Dialer/Transmitter or Local Alarm:
Wiring Diagram for
Bell or Siren Cut Off:
Altronix is not responsible for any typographical errors.
140 58th Street, Brooklyn, New York 11220 USA | phone:
718-567-8181 | fax:
718-567-9056
website: www.altronix.com | e-mail:
info@altronix.com | Lifetime Warranty
II6030 – Rev. 081205
I13U