LITETRONICS AL-Series LED Area Lights Installation Guide
- June 15, 2024
- Litetronics
Table of Contents
LITETRONICS AL-Series LED Area Lights
WHAT COMES IN THE BOX
3 pin shorting cap Pluggable sensor socket
3 1/2 ft cable, Type 3 lens Installation Instructions
TOOLS NEEDED
- Phillips Screwdriver
- Allen Wrench
SAFETY INSTRUCTIONS AND WARNINGS
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE
OBSERVED.
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
Litetronics fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Risk of fire or electric shock. Area light installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
Be certain electrical power is OFF before and during installation and maintenance.
Area light must be connected to a wiring system with an equipment – grounding conductor.
Make sure the supply voltage is the same as the rated luminaire voltage.
Only the open holes indicated in the photographs and/or drawings may be made or altered as a result of this kit installation. Do not leave any other open holes in an enclosure of wiring or electrical components.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or sharp objects.
Suitable for wet locations.
ATTENTION
- Please check if there is any damage during shipping. If so, please contact Litetronics customer service.
- Please read the installation instruction carefully to check whether all the accessories are included.
- After confirmation, install the fixture according to installation steps.
INSTALLATION PROCEDURE
WIRING DIAGRAM
120V & 277V
*For 240V, follow 480V wiring instructions
480V
*For 347V, follow 120-277V wiring instructions
INSTRUCTIONS FOR SHORTING CAP
-
Unless optional Photocell device (Ordered Separately) is to be installed, shorting cap should be installed on the back of light:
( Figure 3 )
-
CCT & Wattage adjustment ( Figure 4 )
Step 1: Unscrew the 3/4 plug (CCT & Wattage Selector)
Step 2: Adjust the integrated switch for CCT & Wattage adjustment to get the desired CCT and Wattage according to the label on the fixture;
Step 3: Install and tighten the 3/4 plug;
THE LENS DEFAULT SETTING, THE CENTER MARKER ON THE FIXTURE IS SET TO “TYPE
III”. (FIGURE 7)
Lens rotation instructions (if required). To rotate the lens follow the next
steps:
Step 1: Turn off power.
Step 2: Using a Phillips screwdriver, unscrew the 25 screws that
hold the lens in place.
Step 3: Remove lens.
Step 4: To adjust lens to a left/forward distribution rotate lens
clockwise 90°. To confirm proper rotation, the letter “L”
should be correctly set at the center square slot at the
base of the fixture. ( Figure 8 )
Step 5: To adjust lens to a right/forward distribution rotate lens
counter-clockwise 90°. To confirm proper rotation, the letter “R” should be
correctly set at the center square slot at the base of the fixture. ( Figure
9 )
Step 6: Secure lens is in the proper position and replace all 25 screws.
Step 7: Make sure the installation is complete and secure before turn on
the power.
Customer Support
WWW.LITETRONICS.COM
CustomerService@Litetronics.com or
1-800-860-3392
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>