Ksix BXTW03N Truebudes 2 Earphones User Manual

Truebudes 2 Earphones
User Manual

Technical information

• Bluetooth Connectivity V 5.0
• Bluetooth profiles HSP, HFP, A2DP, AVRCP
• Integrated microphone
• Operational range: 10 m
• Frequency range: 20Hz-22Khz
• Maximum power: 5mW
• Impedance: 32ohm
• Sensitivity: ±42db
• Battery capacity: 35 mAh (each earpiece)
• Battery capacity of the case: 300 mAh
• Time in play mode: 6 hours + 14 hours with the charging case
• Earphones Charging time: 1-2 hours
• Type C USB-USB cable included
• Charging case voltage: 5V
• Talking time: 3-4 hours
• 3 interchangeable ear tips set included (S, M,

Illustration

1. MIC
2. Touch Button
3. Light
4. Type-c
5. Light

How to use them

Touch Button (Left Earphone)

• Power on: Long press for 3 seconds
• Power off : Long press for 4 seconds
• Play/Pause : One-click
• SIRI: Long press for 1-second
• Answer the call: One-click
• Refuse the incoming call: Long press for 1 second
• Cancel dial : One-click
• Hang up call : One-click
• Turn volume down Three clicks
• Previous song : Double click

Touch Button (Right Earphone)

• Power on Long press for 3 seconds
• Power of the Long press for 4 seconds
• Play/Pause: One-click
• Answer the call : One-click
• Refuse the incoming call: Long press for 1 second
• Cancel dial: One-click
• Hang up call: One-click
• Turn volume up to three clicks
• Next song : Double click

Connect the True Buds earpieces to each other

1. Take the earphones out of the case to turn them on.
2. Once they are on, the LED indicators will blink blue and red.
3. After a few seconds, both LEDs will blink blue slowly. This means that the earpieces have linked to each other.

Connect both True Buds earpieces to your mobile device

1. Once the earpieces have linked to each other, turn on Bluetooth on your mobile device.
2. Find and select the signal named “TRUEBUDS” to link the earphones to your mobile device. When turning the earphones on, they will reconnect to the last linked mobile device, as long as Bluetooth is activated on the device.
   Note: If it is not possible to connect the earpieces to each other by following the steps given, restart them.

How to restart (factory reset) True Buds earphones

1. Turn off Bluetooth on your mobile device and turn off both earpieces.
2. Turn on both earpieces at the same time.
3. Wait for a few seconds until the earpieces connect to each other. Once they have linked, both LED indicators will blink red & white, slowly.
4. Turn on Bluetooth on your mobile device and connect it to the earphones.

How to charge the battery of the True Buds earphones
When the battery of the True Buds earphones is low or depleted, charge them using the case.

1. Place the earphones in the case.

2. Connect the case to a power source using the TYPE-C-USB cable. You can connect it to a USB port on a computer or a laptop.
   Note: Connecting the charging case to a power outlet requires an adaptor that is not included with this product

3. While the earphones are charging, the LED indicators will turn on red.

4. When the earphones are through charging, the LED indicators will turn off. The case can also be used to charge the earphones independently, without needing to be connected to a power source.

How to charge the earphones only using the charging case

1. First, you should charge the case’s internal battery. To do this, connect the case to a power source using the Type C USB-USB cable.
2. While the case is charging the LED indicator will blink white. When the case’s internal battery is fully charged, the LED indicator will remain white, without blinking.
3. Once the case’s internal battery is fully charged, place the earphones inside the case to charge them.

Maintenance recommendations

• Regularly clean the product with a dry cloth. The product must be disconnected or switched off when you clean it.
• Keep the connectors and/ or ports free from dust, lint, etc. to prevent improper connections.
• Avoid breaking the device. Do not put objects over it or bend it too strong.
• If the product includes a cable do not bend it too strong and do not pull from it to unplug the product.
• Do not wet the product. Keep it always in a dry place, away from humidity.
• When not using the product, store it in a place free from dust, dirt, lint, liquids, etc.
• If water or other liquids enter the product interior, unplug it immediately from any attached power source or device it is connected to.
• Avoid dropping or hitting the product. It might be damaged.
• Do not use the product for anything other than its intended use.
• Please recycle the product in accordance with local environmental laws and regulations.

Safety information
Please read the following instructions before using the device for the first time:

• When you use a device keep it away from heat sources (fire) and from humidity sources (water and other liquids).
• If the product is wet or damaged do not use it.
• Do not use the product with wet hands.
• Do not leave the product in contact with flammable materials.
• Do not expose the product to high temperatures (for example: inside a car during hot weather)
• Do not throw the product into fire.
• Keep the product away from children.
• Disconnect or switch off the product if you are not going to use it for a long period of time.
• Do not use the device if you perceive any visible defects.
• Do not attempt to open or puncture the product. You might damage it.
• Do not use the product with incompatible devices.
• Do not dismount or modify the product. These actions will invalidate the Warranty.

Legal Note
Hereby, Atlantis Internacional S.L. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EC. The features and functions described in this manual are based on tests made by Atlantis Internacional S.L. It is the user’s responsibility to examine and verify the product after its purchase. Atlantis Internacional S.L. is not responsible and will never be liable for any personal loss or injury, economical loss, material loss, or any damage due to misuse, abuse, or improper installation of the product. For electronical devices with Bluetooth: Atlantis Internacional S.L. is not responsible and will never be liable for any function, communication, and connection failure between the product and Bluetooth-enabled devices.
Electronic and electrical devices disposal
This symbol indicates that electrical and electronic equipment is to be collected separately.

• This product is designated for separate collection at an appropriate collection point. Do not dispose of as household waste.
• The final price of this product includes the cost necessary for the correct environmental management of the generated waste.
• If the equipment uses batteries, they must be removed from the equipment and disposed of in an appropriate collection center. If the batteries cannot be removed, do not attempt to do it yourself since it must be done by a qualified professional.
• Separate collection and recycling helps conserve natural resources and prevent negative consequences for human health and the environment that might result from incorrect disposal.
• For more information, contact the retailer or the local authorities in charge of waste management.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>