CONRAD R-751S IR Wall Running Master Car Instruction Manual

June 6, 2024
CONRAD

CONRAD R-751S IR Wall Running Master Car

PRODUCT PARAMETERS

  1. Product name: Wall running master car
  2. Product size: 15cm 8cm 4cm (NO.R-751S / NO.R-752S / NO.R-753S)
  3. Transmitter battery: 2 * AAA batteries (not included)
  4. Car battery: 3.7V 500mAh Li-ion rechargeable battery
  5. Control distance: <8 meters
  6. Control time: About 20-25 min on floor About 7-10min on wall and ceiling
  7. Charging time: about 60 minutes
  8. Color: Blue/ Red/ Green
  9. Charging input: 5VDC 0.5A

CONRAD R-751S IR Wall Running Master Car FIG 2PARTS OF REMOTE CONTROLCONRAD R-751S IR Wall Running Master Car
FIG 3

CHARGING PROCEDURE

The charging method of the USB charger ( 3.7V lithium )

  1. Connect the USB charger cable to the computer interface or the USB adapter, then connect the cable to the charging port.The red indicator turns on when charging. About 60 minutes later, the indicator turns off, showing that charging is completed.
  2. Use a crossing screwdriver to wrench the screws on the backward of the controller in
    an anti-clockwise direction, open the battery cover. Insert 2 AAA batteries inside then close the battery cover and screw it in a clockwise direction.

CONTROL METHODS

The process of frequency infrared RC wall climing car.

  1. Turn on the RC car switch to “on” position, the wall climing mode is opened. Turn on the RC car switch to the middle of on and off, the floor mode is opened.
  2. Then turn on the transmitter switch to “on” position, the red indicator of the controller keeps on, showing the frequency bind is successful.
  3. About the demo function, when turn the switch of “demo”on, the red indicator of the controller flashing, showing the demo mode is opened, the car can do the action by itself.
  4. Control range of the remote control car is under 8 meters. Pls avoid to overstep this control range Otherwise the remote control car will be out of controlled.
  5. Play time of the RC car, if on a full charge condition. The remote control car could be used about 20-25 mintutes when it played on the floor. If it is played on the wall, the play time is about
    7- 10 minutes.

DELIVERY CONTENT

  1. RC car with 3.7V 500mAh Li-ion rechargeable battery inside *1
  2. Controller * 1
  3. USB cable * 1
  4. Manual * 1

NOTICE

  1. The non-rechargeab le battery (2*AAA batteries) are not to be charged.
  2. Rechargeable batteries are only to be charged under adult supervision.
  3. Not for children under 6 years old.
  4. Always keep parts dry.
  5. Always keep all chemicals, small parts and anything electrical out of the reach of children.
  6. Please do not be a bad battery, battery pack into fire or decomposition in the water to avoid accidents.
  7. Never place any portion of the vehicle in your mouth as it could cause serious injury or even death.
  8. To charge the battery you must use only the stock included charger or a suitably compatible battery charger. Failure to do so may result in a fire causing property damage and/or persional injury.
  9. Aways disconnect the battery after charging, and let the charger cold between charge again
  10. Check the vehicle regularly, make sure the vehicle is in good shape.
  11. When the installation or replacement of the battery. Batteries are to be inserted with correct polarity.
  12. Wall climing car use a set of 3.7V 500mAh Li-ion rechargeable battery.
  13. Remote control use 2*AAA batteries.

MAINTENANCE

  1. Do not insolation on sun and calefaction for a long time.
  2. Turn off the power of the transmitter and the remote control car when not in use.
  3. Checking if all screws are loose or not.
  4. Remove the batteries in the remote controller when you do not use the controller.
  5. Different type of batteries or new and used batteries are not to be mixed.
  6. Exhausted batteries are to be removed from the toy.
  7. The terminals are not to be short-circuited.

Not suitable for children under 36 months.
Small parts, choking hazard.
The toy is only to be connected to Class II equipment bearing the following symbol.

Distributed by Conrad Electronic SE Klaus-Conrad-Str.1 D-92240 Hirschasu

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals