BIGGIES Window Well Scenes Installation Guide

June 8, 2024
BIGGIES

BIGGIES Window Well Scenes

Window Well Scenes

Installation Instructions

Step 1 – Prepare the Window Well

Clean out debris in the window well and remove a few inches of rock or other material from the bottom of the window well; this will enable you to roll the panel into place with greater ease when installing it and will put the lower edge below the rocks when they are replaced which will anchor it.
Measure your window well in several places from the top to the bottom (height) and from side to side (width) to check for plumb. Caution: Be generous with your measurements; the curved dimension may be difficult to measure perfectly. You can always trim more off, but you can’t add any back!
Clean the metal or concrete with rubbing alcohol or other appropriate solvent to remove any residue where the adhesive strips will be placed. If your window well is especially deep, plan so that about one inch of rock covers the bottom edge of the liner. Don’t be concerned if the liner doesn’t reach the top rim of the well; the top cannot be seen from the room. Clean out debris in the window well and remove a few inches of rock or other material from the bottom of the window well; this will enable you to roll the panel into place with greater ease when installing it and will put the lower edge below the rocks when they are replaced which will anchor it.
Measure your window well in several places from the top to the bottom (height) and from side to side (width) to check for plumb. Caution: Be generous with your measurements; the curved dimension may be difficult to measure perfectly. You can always trim more off, but you can’t add any back!
Clean the metal or concrete with rubbing alcohol or other appropriate solvent to remove any residue where the adhesive strips will be placed. If your window well is especially deep, plan so that about one inch of rock covers the bottom edge of the liner. Don’t be concerned if the liner doesn’t reach the top rim of the well; the top cannot be seen from the room.
Installation Instructions

Step 2 – Measure the Window Well

Layout your Window Well Scenes image side upon a fiat surface. Anchor the corners with something heavy if needed. Mark your window well measurements to select the area that looks best for your window well.
Installation Instructions

Step 3 – Trim to Size

Using a straight edge and a sharp blade/utility knife, or using appropriate scissors, carefully cut along the lines you made in step2. Protect the surface underneath the panel with a piece of wood or cardboard to avoid damage from the blade. Place the liner into the window well along the curve to make any final size adjustments.
Installation Instructions

Step 4 – Attach the Window Well Scene

Attach the individual paired hook & loop fasteners to the window well on the ridges that bump out toward the room. Avoid placing pieces on wet or rusted are as. Leaving the male and female sides connected as well as the backing paper, attach the strips to the metal. Put four pieces down each side being sure to hit the spots where the corners will be, four down the middle, and three down each curve. Put the remaining two pieces along the top edge. Starting on the free side of the rolled liner, remove the remaining backing paper from a set of fasteners. Start rolling out the liner, and rub on the liner where the fasteners are.
Installation Instructions

Step 5 – Finish and Enjoy the view!

Replace the rock or other material in the bottom of the well to cover the bottom edge of the liner and add any additional decoration desired such as larger rocks, driftwood, or plants. Stand back and admire the dramatic change in your view. Enjoy!
Installation Instructions

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals