KODAK C300 Digital Camera User Guide
- June 6, 2024
- Kodak
Table of Contents
C300 Digital Camera
User Guide
Before Start
-
this unit has built-in battery. Charge this unit before using it.
-
How to change cartridge.
Power, Shutter and Active Status
Smartphone App Installation
- Go to GOOGLE Play Store in your smartphone.
- Search “KODAK Instant Printer”
- Install “KODAK Instant Printer’. Into your smartphone
BLUETOOTH Connection
- Turn on BLUETOOTH in your smartphone.
- Turn on this unit.
- Go to BLUETOOTH setting in your smartphone and select.
“KODAK Instant-XXXX” (‘XXXX’ are 4 digits combination of numbers and letters.)
Take a Photo
- Tum on this unit by pressing power button.
- Press shutter button to take the photo after positioning the subject in LCD screen.
- Taken photos are deleted when the camera is powered OFF.
Control Panel
Menu
- Border : You can select border of printed image.
- Filter : You can select filters when you take the photo.
- Flash : You can set Flash Auto or Off.
Printing in the App
1) Launch APP
2) Select Gallery
3) Select Photo
4) Select the number of photo
5) Select Print
Note
-
Photo Paper will go in and out 4 times (Yellow, Magenta, Cyan, Overcoating).
Do not touch the paper during printing process for best image quality -
Do not pull paper out by force during printing.
-
Do not place an object in front of the paper exit slot.
-
Use the latest application for best print quality. Check the latest app version from
GOOGLE Play Store and APPLE APP STORE.
-
Printer has built-in battery. Charge the printer before using.
-
Handle with care during charging to prevent electric shock.
-
Do not disassemble or deform.
-
Avoid too high or low temperature or humidity.
-
The higher resolution the image has, the higher quality the printed photo has.
Recommended image size is 1280*2448 pixel. -
Operating Temperature : O-40’C (32-104 °F)
Troubleshooting
FCC (Federal Communications Commission)
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two condition:
(1)This device may not cause harmful interference, ‘and
(2) This device must accept any interference received,
including interference that may cause undesired operation
Caution: Any changes or modifications to the equipment not express
approved by the party responsible for compliance could void user’s
authority to operate the equipment.
This appliance and its antenna must not be co-located or operation in
conjunction
with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment has been tested and found to comply with the limits for a Class
B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause
harmful interference to radio or television reception, which can be determined
by
turning the equipment off and on, the user is encouraged to correct the
interference
by one of the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver,
- Connect the equipment into an outlet on a circuit different from which the receiver is connected,
- Consult the dealer or an experienced radio/TV technician for help.
The Kodak trademark, logo and trade dress are used under license
from Kodak.
www.kodakphotoprinter.com
Copyright © Prinics., Ltd