SUB-ZERO SZPA-P12-P15 Portable Speaker User Manual
- June 6, 2024
- SUB-ZERO
Table of Contents
SUB-ZERO SZPA-P12-P15 Portable Speaker User Manual
WARNING
Do not open cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel
Do not place the product in a location near a heat source such as a radiator,
or in an area subject to direct sunlight, excessive dust, mechanical vibration
or shock
The product must not be exposed to dripping or splashing and no objects filled
with liquids, such as vases, shall be placed on the product
No naked flame sources, such as lighted candles, should be placed on the
product
Allow adequate air circulation and avoid obstructing vents (if present) to
prevent internal heat build-up.
The ventillation must not be impeded by covering the appliance with items such
as newspapers, tablecloths, curtains etc.
The mains plug is used to disconnect the appliance from the mains supply.
Ensure that the mains outlet is easily-accessible and remove the plug from the
mains outlet if you notice any abnormality with the appliance.
If used improperly, batteries may explode or leak and cause damage or injury.
In the interest of safety:
Make sure you observe the correct polarity when replacing batteries
Avoid using new batteries together with used ones
Avoid mixing different types of batteries
Remove batteries if the appliance is to remain unused for an extended period
of time
Never keep batteries together with metallic objects such as ballpoint pens,
necklaces, hairpins, etc.
Used batteries must be disposed of in compliance with whatever regulations for
their safe disposal that may be observed in the region in which you live.
Batteries must not be exposed to excessive heat such as sunshine, fire or the
like.
Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent
INTRODUCTION
Thank you for purchasing the SZPA-P12 / SZPA-P15. To get the most out of your product, please read this manual carefully
BOX CONTENTS
- 1 x SZPA-P12 / SZPA-P15
- 2 x Wireless handheld microphones
- 1 x UK power cable
- 1 x EU power cable
- 1 x User manual
FEATURES
- Powerful battery-operated 12/15” PA system, with media player and 2 mics.
- 12” speaker produces 60W RMS / 100W Peak / 240W Max.
- 15” speaker produces 80W RMS / 140W Peak / 320W Max.
- Digital media player offers Bluetooth, USB and SD connectivity.
- Built-in rechargeable battery with up to 6 hours of battery life.
CONTROLS & FUNCTIONS
-
DIGITAL MEDIA PLAYER
Enables you to play music through the speaker using a variety of platforms.-
MODE BUTTON
Change between different input modes
(USB, SD and Bluetooth) -
PLAY/PAUSE BUTTON
(For USB and SD modes) -
REPEAT BUTTON
For selecting play and repeat functions -
SKIP
With short press / SCROLL with long press -
DISPLAY SCREEN
-
SD CARD INPUT
-
USB DRIVE INPUT
-
BLUETOOTH WIRELESS RECEIVER
-
-
MIC GAIN
Increase and decrease the volume of the microphone inputs (7). Note that this does not control the volume of the wireless microphones. -
LINE LEVEL
Increase and decrease the volume of the line input. -
ECHO
Increase or decrease the amount of echo to be added to the inputs. -
MP3 VOLUME
Increase or decrease the level of the digital media player input. -
VOLUME
Increase or decrease the overall volume of the master output of the speaker. -
MIC INPUTS 2 x TS ¼ jack inputs suitable for low impedence microphone signals. Note, this input does not support microphones that require phantom power.
-
LINE INPUTS Stereo RCA inputs suitable for high impedance line level signals.
-
MIX OUTPUT Stereo RCA output that provides a master output of the speaker’s mix at a line level signal.
-
GRAPHIC EQ Control the frequencies of the master output at 100Hz, 330Hz, 1KHz, 3.5KHz and 10KHz. Boost or limit the frequency by +/-12dB.
-
WIRELESS MICROPHONE VOLUME KNOBS control the volume of the wireless microphones. Power to the receiver can be switched on and off using the on/off button.
-
BATTERY CHARGE INDICATOR 4 level indicator to show the battery life. The red light indicator flashes when charge level is below 25%. At this point, you need to recharge the battery as soon as possible to continue use.
-
ANTENNAS
Receive radio frequency signals from the wireless microphones. Be sure these are extended when in use with the wireless microphones -
ANTENNAS
Receive radio frequency signals from the wireless microphones. Be sure these are extended when in use with the wireless microphones. -
FUSE
This fuse is replaceable. Ensure to replace only with a like for like fuse. Failure to do this could damage the product. Before replacing, remove the unit from any external power supply and ensure the mains plug is not attached. -
MAINS CONNECTION
Use only the power cable supplied with the product.
This power socket is fitted with a F1A at 250V fuse.
Ensure to replace only with a like for like fuse.
Failure to do this could damage the product. Before replacing, remove the unit from any external power supply and ensure the mains plug is not attached. -
POWER SWITCH
This turns the device on and off. Note, if the power switch is off but still connected to a mains connection, the battery will continue to charge.
WIRELESS MICROPHONE
-
GRILL
This protects the microphone from damage. Do not take the grill off, as there are no user serviceable parts inside. -
LED
This light flashes once turned on and then will not light again under normal condition. If the battery is low, the LED will flash. -
ON/OFF SWITCH
This has three positions. Off at bottom, mute in the middle (RF signal is operative but audio is muted), and on at the top. -
BATTERY COMPARTMENT
This requires 2 x AA batteries (1.5v each). Do not use any other kind of battery with this microphone. -
BATTERY COVER
To remove, push the top of the door slightly and slide downwards. Opposite is applicable to reinsert.
USING THE MEDIA PLAYER
-
USB INPUT
Allows you to play any .mp3, .wma or .wav files. -
SD CARD INPUT
Allows you to play any .mp3, .wma or .wav files. -
LCD DISPLAY
Shows you all the functions that are currently be used. -
REMOTE CONTROL SENSOR (controller not included on this model)
-
MODE SELECT BUTTON
Cycle between Bluetooth, SD and USB connections. -
PLAY/PAUSE
Allow you to play and pause the audio. -
STOP
Allow you to stop the audio -
LOOP
Allow you to loop the current audio track (SD card and USB only). Pressing repetedly allows you to change between looping current song, repeating all songs in the particular folder, loop playback of all songs in all folders and random playback. -
SKIP BACK
Go back one track (short press), or rewind (long press).
USING THE MEDIA PLAYER -
SKIP FORWARD
Go forward one track (short press), or fast forward (long press).
BLUETOOTH CONNECTION
To connect a Bluetooth device to the speakers digital media player, please follow the below steps.
- Ensure that the speaker is powered on and within range of the Bluetooth device.
- Press the MODE button on the speakers digital media player until ‘Bluetooth’ is displayed on the screen.
- Open the Bluetooth settings on the Bluetooth enabled device.
- Scan for Bluetooth devices and search for ‘SZPA-P12’ or ‘SZPA-P15’ in the devices list.
- Select ‘SZPA-P12’ or ‘SZPA-P15’. The Bluetooth enabled device should confirm that it is now connected.
- Play audio from the Bluetooth enabled device, ensuring that volume is turned up.
- Turn up the MP3 VOL dial on the speaker to the required level.
WIRELESS MICROPHONE INFO
This product fully complies with all relevant standards in the Radio Equipment Directive (RED) 2014/53/EU. A full declaration of conformity is available at info@gear4music. com.
Please see the map for information about use of the included wireless microphone in your region. More information can be obtained at info@gear4music.com or by contacting your local authority.
We want you to be completely satisfied with your purchase. Should you have any
questions or queries about this product, contact the Gear4music hotline on
+44 (0)330 365 4444 or at
info@gear4music.com
SPECIFICATIONS
SZPA-P12
-
Speaker Size: 12” + 1” Compression Driver
-
Amplifier Class: Class AB
-
Output Power: 60W RMS
85W PEAK
240W MAX -
Frequency Response: 68Hz – 19KHz
-
Max SPL: 109dB
-
Protection Circuits: Short Circuit, Overcurrent
Supported Media
- Platforms: Bluetooth, USB, SD
- Input Channels: 2 x ¼” Jack Mic in, 1 x stereo RCA line in
- Output Channels: 1 x stereo RCA
Wireless Microphone
- Frequency: 863.1 + 864.5MHz
- Max RF Power: 10mW Mic Frequency
- Response: 50Hz – 17KHz
- Mains Power: 230V at 50HzAC IEC cable
- Mains Fuse Type: T1A, 250V
- Battery Fuse Type: T10A, 250V
- Power Consumption: 56W
- Battery Life: Up to 4 hours
- Weight: 12.2Kg
- Dimensions: 420 x 645 x 345mm
SZPA-P15
-
Speaker Size: 15” + 1” Compression Driver
-
Amplifier Class: Class AB
-
Output Power: 80W RMS
115W PEAK
320W MAX -
Frequency Response: 68Hz – 19KHz
-
Max SPL: 112dB
-
Protection Circuits: Short Cirrcuit, Overcurrent
Supported Media
- Platforms: Bluetooth, USB, SD
- Input Channels: 2 x ¼” Jack Mic in, 1 x stereo RCA line in
- Output Channels: 1 x stereo RCA Wireless Microphone
- Frequency: 863.1 + 864.5MHz
- Max RF Power: 10mW
Mic Frequency
- Response: 50Hz – 17KHz
- Mains Power: 230V at 50HzAC IEC cable
- Mains Fuse Type: T1A, 250V
- Battery Fuse Type: T10A, 250V
- Power Consumption: 56W
- Battery Life: Up to 4 hours
- Weight: 17.2Kg
- Dimensions: 485 x 690 x 345mm
If you have any more questions about this product, please do not hesitate to contact the Gear4music Customer Service Team on: +44 (0) 330 365 4444 or info@gear4music.com
References
- Gear4music Deutschland | Musikinstrumente, -equipment und -software
- Gear4music Danmark | Musikinstrumenter, -udstyr og -software
- Gear4music Nederland | Muziekinstrumenten, -apparatuur & -software
- Gear4music Sverige | Musikinstrument, Utrustning & Mjukvara
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>