SUB-ZERO SZ-SATURN-5VC Saturn 5VC Combo Amplifier User Manual

: June 6, 2024
: SUB-ZERO

Table of Contents

INTRODUCTION
BOX CONTENTS
PRODUCT FEATURES
SPECIFICATIONS
FUNCTIONS
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

SATURN 5VC
COMBO
AMPLIFIER
SZ-SATURN-5VC
USER MANUAL

INTRODUCTION

Thank you for purchasing the SubZero Saturn 5VC 5W combo amplifier. To get the most out of your product, please read this manual carefully.

BOX CONTENTS

SubZero Saturn 5VC amplifier.
UK mains cable.
EU mains cable.

PRODUCT FEATURES

Celestion Super 8 speaker.
All tube 5W architecture.
Switchable 1W and 5W outputs.
Tone control for perfect sound.

SPECIFICATIONS

Input Power ………..220-240VAC, 50/60Hz
Power
Consumption ………50W Max
Speaker ………….. Celestion Super 8
Preamp Tube ……….1x 12AX7
Power Tube ………..1x 6V6GT
Input Impedance ……1MΩ
Speaker Output …….Max 5W RMS
Speaker Output
Impedance ………..Minimum 8Ω
Frequency Range ……80Hz – 10kHz
S/N Ration …………-75dB
THD. . . . . . . . . . . . . . . . . . 0.5%
Dimensions ………..338306205mm
Weight ……………8.0kg

FUNCTIONS

INPUT CONNECTOR
Connect your guitar to this connector using a 6.3mm TS jack cable.
HIGH/LOW SWITCH
Switch between 1W (low) and 5W (high) power output using this switch.
TONE CONTROL
Adjust the tone of your amplifier using this dial. Fully anticlockwise will produce a thinner sound, fully clockwise will produce a broader sound.
VOLUME CONTROL
Adjust this dial to control the overall output sound from the amplifier. This dial will also affect the volume sent to the speaker output connector on the rear of the amplifier.
STANDBY LIGHT
This light will illuminate when the amplifier is switched on.
POWER SWITCH
This switch turns the amplifier on and off. When the amplifier is switched on, allow a moment for the tubes to warm up before playing. This will increase the lifespan of the tubes and create a better output sound.
SPEAKER OUT CONNECTOR
Connect an external speaker to this connector using a 6.3 TS speaker jack cable.
MAINS POWER CONNECTOR
Connect the amplifier to the mains power using this connector. Only use the main cable provided with the product.

NOTE: This connection outputs at an amplifier level. It is recommended to use a speaker jack cable capable of carrying the required load.
WARNING!
Do not open cover. No user-serviceable parts inside. Refer servicing to qualified service personnel Do not place the product in a location near a heat source such as a radiator, or in an area subject to direct sunlight, excessive dust, mechanical vibration, or shock The product must not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the product No naked flame sources, such as lighted candles, should be placed on the product The mains plug is used to disconnect the appliance from the mains supply. Ensure that the main outlet is easily- accessible and remove the plug from the main outlet if you notice any abnormality with the appliance.

If you have any more questions about this product, please do not hesitate to contact the
Gear4music Customer Service Team on: +44 (0) 330 365 4444 or info@gear4music.com