SUB-ZERO 9063575 Tubular and Pro Handle User Guide
- May 15, 2024
- SUB-ZERO
Table of Contents
SUB-ZERO 9063575 Tubular and Pro Handle
CONTENTS
- 1 Handle
- 2 Standoff
- 2 Screw, #10-24 x 2″ (tubular handle only)
- 2 Screw, #10-24 x 21 /4″
- 2 Screw, #10-24 x 21/2″ (pro handle only)
- 2 Washer, flat
- 2 Washer, star
HANDLE DIMENSIONS
TUBULAR HANDLE | A |
---|---|
603/4“ | 557/16“ |
501/8“ | 471/8“ |
43″ | 369/16“ |
401/8“ | 3413/16“ |
37″ | 309/16“ |
331/4“ | 301/4“ |
31″ | 249/16“ |
271/4“ | 241/4“ |
25″ | 189/16“ |
241/4“ | 211/4“ |
221/2“ | 191/2“ |
211/4“ | 181/4“ |
201/2“ | 171/2“ |
PRO HANDLE | |
--- | --- |
5611/16“ | 557/16“ |
483/8“ | 471/8“ |
42″ | 403/4“ |
361/16“ | 3413/16“ |
311/2“ | 301/4“ |
30″ | 283/4“ |
251/2“ | 241/2“ |
24″ | 223/4“ |
221/2“ | 211/4“ |
201/2“ | 191/4“ |
191/2“ | 181/4“ |
TUBULAR AND PRO HANDLE INSTALLATION
Panels thicker than 3/4” may require additional counter bore depth or longer screws.
-
Determine the overall length of the handle.
IMPORTANT NOTE: For pro handles, the overall length includes the standoffs. -
Use the chart to determine the correct hole location, then mark and drill two 7/32” holes.
-
Counter bore panels so the screw heads and washers are completely recessed.
-
Place a star and flat washer on each screw, then insert the screw through the panel.
-
Insert the screws through the standoffs and into the handle.
-
Tighten the screws to secure the handle to the panel.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>