GoGEN TWS BAR Wireless Headphone User Manual
- June 6, 2024
- Gogen
Table of Contents
GoGEN TWS BAR Wireless Headphone User Manual
SECURITY PRECAUTIONS
In order to have a proper and safe use of the headset, please read this user manual in detail and save it. Be aware of the following guidelines when using your headset:
WARNING
- You should adjust the volume carefully when using the headset to prevent hearing damage.
- Please stop using the headset in potentially hazardous situations to ensure your safety.
- Please avoid using the headset to listen to music, make or receive calls which may cause a distraction while driving.
- Put this product and its accessories somewhere out of the reach of children, to avoid a fatal danger caused by inappropriate use.
- You should keep water from entering the headset, which may cause damage to the sound quality or the headset.
- You should avoid turning the volume so high that you can’t hear anything around you. If you feel a tinnitus or the volume is too high, please reduce the volume.
- Stop using the headset if you feel obvious discomfort, irritation or have other adverse reactions.
- The headset should not be stored or used at temperatures below -10 °C or above 55 °C which may shorten headset or battery life
TECHNICAL SPECIFICATIONS
Bluetooth Version: V 5.0
Bluetooth Profile: HSP, HFP, A2DP, AVRCP
Operating range: 10 m
Frequency Response: 20 Hz – 20 KHz
Rated Power: 3 mW
Sensitivity: 95 dB (±3 dB) @ 1 KHz
Impedance: 32 Ω ± 10%
EIRP: 11,5 dBm
Battery: Li-Polymer 500 mAh Charging Case + 30 mAh X 2 earbuds
Music playing time: up to 4 hours + 12 hours with charging case
N.W.: 4 g / earbud, 40 g including charging case
ACCESSORIES
Eartips, USB Charge Cable, Charging Case DEVICE LAYOUT
-
Touch control area
-
Charging interface
-
Charging case battery indicator
POWER ON & PAIRING
Option 1: AUTO ON & PAIRING
With the two headsets in case and lid open to active Power ON. Take out the
headsets and wait about 10 seconds until LEFT & RIGHT earbuds AUTO paired. The
LED lights will flash orange and white alternately.
Option 2: Manually ON & PAIRING
Pick up the headset from the charging case, long tap the L&R earbuds for 6
seconds until they powered OFF. After a while (5 seconds), long tap the L&R
earbuds for 3-5 seconds. After connecting, the LED lights will flash orange
and white alternately. The left earbud is working as a Master. The right is
working as a Slave.
RESET
In case of failure pairing or unnormal working, you need to RESET the earbuds
as following:
Long press and hold the multi-functional key of both earbuds and put them into
the charging case to charge, then release the multi-functional key
BLUETOOTH CONNECTION STEPS
- Please keep your headset and mobile phone as close as you can, within 1 meter.
- Turn on “Bluetooth” in setting on your phone or other devices, and then find and select GOGTWSBAR.
- Click on GOGTWSBAR and Bluetooth Headset gets connected with your phone or devices automatically. (Some may require pass code which is “0000” (4 zeros)).
TAP CONTROL INSTRUCTIONS
FUNCTION | CURRENT STATUS | ACTION |
---|---|---|
ACTIVATOR OFF | CONNECTING TO PHONE | **Double press L or R earphone |
to acitavte Sid
ANSWER CALL| INCOMING CALL| Short press the L or R earphone
END CALL| ON CALL| Short press the L or R earphone
REJECT CALL| INCOMING CALL| Press L or R earphone for 2 seconds
PLAY & PAUSE MUSIC| MUSIC PLAYING| Short press L or R earphone
PREVIOUS TRACK| MUSIC PLAYING| Press L earphone for 2 seconds
NEXT TRACK| MUSIC PLAYING| Press R earphone for 2 seconds**
CHARGING
CHARGING WAYS OF HEADSET
When the earbuds are in low battery, there is a voice prompt, put the earbuds
into the charging case and close the charging case to charge the earbuds. The
bottom of the charging case‘s indicator light is always on an orange during
charging, the orange light will be off after the earbuds are fully charged.
CHARGING WAYS OF CHARGING BASE
„The charging case indicates low battery: open the charging case, the top of
the charging box‘s white indicator is always on; When the battery status is
lower than 25%, the top al charging box‘s white indicator will flicker.
Using a USB cable to charge the charging case. The bottom of charging case‘s
indicator will be
orange light flashes accordingly(orange light flashes 1 time every 2 seconds,
the battery capacity is 0-25%; Orange light flashes 2 times every 2 seconds,
the battery capacity is 25%-50%; Orange light flashes 3 times every 2 seconds,
the battery capacity is 50%-75%; Orange light flashes 4 times every 2 seconds,
the battery capacity is 75-100%.
When the charging box is fully charged, the charging indicator light is always
on orange.
WARNING
-
You must select a qualified charger from a regular manufacturer. (Charging Voltage: 5V Charging Current: 900mA for charging case)
-
A fully charged headset will lose its power automatically if left unused. It is recommended to charge the headset each three months.
-
Do not leave the headset in a too hot or too cold condition (best between -10°C and +40°C) which may affect the headset‘s operations although it is fully.
-
Please wear this Headset properly for best tone quality.
Do not disassemble hardware. Please use soft and dry cottons for cleaning. -
Make sure the headset is fully charged before first use.
-
This Headset is not waterproof. Do not use it while swimming or diving.
-
If do not use this Headset for long time, please charge once a week to extend battery life.
-
Keep your Headset and device as close as you can to avoid interference of signal path.
WARRANTY
Our product is warranted for 2 full year from the date of purchase. The warranty is provided on all material defects and workmanship. Guarantee of 24 months does not apply to decrease in the accumulator’s effective capacity caused by its use or age. Effective capacity gradually decreases depending on the method of use of the accumulator.
WE RESERVE THE RIGHT TO CHANGE TECHNICAL SPECIFICATIONS.
TO AVOID DANGER OF SUFFOCATION, KEEP THE PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS THIS BAG IS NOT A TOY.
Disposal of old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems)
This symbol on the product or on its packaging indicates that this product
shall not be treated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this
product.
The recycling of materials will help to conserve natural resources. For more
detailed information about recycling of this product, please contact your
local Civic Office, your household waste disposal service or the shop where
you purchased the product.
Hereby, ETA a.s. declares that the radio equipment type TWSBAR is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.gogen.cz/declaration_of_conformity
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>