MUDDY MUD-RBI Remote Beacon Illuminator User Manual
- June 6, 2024
- MUDDY
Table of Contents
MUDDY MUD-RBI Remote Beacon Illuminator
IC STATEMENT
This device complies with Canada ICES-005(B)/NMB-005(B) This device contains
license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
INCLUDED ITEMS
- Remote Beacon Illuminator (RBI) Unit
- Remote Activator
- Mounting Clamp
- Clamp Spacers
- User Manual
- AA 1.5V Battery (x4, for RBI unit)
- CR2032 3V Lithium Battery (in remote)
ABOUT
The Remote Beacon Indicator (RBI) is intended to be mounted to a tree stand to illuminate the tree stand steps for safety. It can also assist in locating a well- hidden tree stand.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications to the device could void the warranty and the user’s authority
to operate the device.
RF warning statement: The device has been evaluated to meet general RF
exposure requirements. The device can be used in portable exposure conditions
without restriction. NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNINGS & DISCLOSURES
- Batteries included are not rechargeable. Trying to recharge can cause damage to battery and unit.
- If handled improperly, the battery may break or leak causing possible corrosion of the device or clothes.
- It is recommended that the same model battery is used for battery replacement.
- Batteries should not come into contact with other metal objects, such as: keys, coins, etc. as this may cause the battery to overheat or short circuit.
Warning! For California Customers: Proposition 65 warnings. This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. www.p65warning.ca.gov
PRODUCT IDENTIFICATION
- Battery Compartment
- Clamp
- Clamp Spacers
- LED
- Power/Pairing Button
SETUP
Installing batteries
- Remove battery cap by turning the cap clockwise.
- Insert the included AA batteries in the proper orientation (refer to (+) and (-) marks on the RBI).
- Reinstall the battery cap by turning clockwise.
WARRANTY
This MUDDY product is covered by a one-year limited warranty. This warranty
covers product with manufacturer defects. Normal wear & tear as well as
product abuse are not covered by the warranty. The warranty is valid only for
the original owner of the product purchased from an authorized retailer.
Tampering with or altering the unit will void the warranty. Any unauthorized
service will void the warranty. Original sales receipt must be produced for
any warranty service and a Return Authorization (RA) number must be obtained
from customer service at 877-269-8490
prior to returning the product. For more information go to
www.gomuddy.com
OPERATION
Pressing the button on the RBI remote will cause all paired RBI units within range to illuminate.
- The remote activator functions at a range of up to 150 yards.
- The light on the RBI units will turn off automatically after 3 minutes.
- Light may be tuned off manually by pressing the button on the RBI unit.
REMOTE PAIRING
The remote activator can be paired to additional RBI units by following these steps:
- With RBI unit OFF, press and hold the power button until main light begins to flash.
- Once flashing, press the button on the remote.
- The light on the RBI unit will turn solid when paired.
(Note: 1 remote activator can be paired with multiple RBI units)
INSTALLATION
The RBI is designed for installation on square tubing used on MUDDY brand tree
stands (¾” – 1”; 20-25mm)
The RBI will also clamp onto round tubing (¾” – 1”; 20-25mm)
Add or remove clamp spacers (included) as needed)
CLAMP ADJUSTMENT
Adjustable clamp can be mounted on horizontal or vertical tubing, with a wide
range of adjustments possible in either orientation.
Remove the center thumbscrew to change the orientation of the clamp.