IRM MOTO R1200RT Sparky Pegs Installation Guide

IRM MOTO R1200RT Sparky Pegs

Specifications

• Compatible with: BMW R1200RT, R1200GS, R1200RS, R1200R
• Parts List:

1. 6-32 x 1-1/2 bolts
2. Retaining clip
3. Mount Footrest

Product Usage Instructions

Installation

1. Remove the clasp that holds the sheathing loom to the ignition coil.
2. Select the correct assembly for each side.
3. Using a 7/64 Allen key, remove the (x4) 6-32 bolts holding the retaining clip onto the Sparky.
4. Place the Sparky Peg into the valve cover.
5. Repeat for the other side.
6. Re-tighten after the first ride.

Care and Maintenance

1. Periodically check the tightness of the retaining clip bolts.
2. Apply grease to the pivot and detent mechanism regularly.

FAQ

Q: How often should I check the tightness of the retaining clip bolts?

A: It is recommended to periodically check the tightness of the retaining clip bolts to ensure proper installation and safety.

Q: What type of grease should be used for the pivot and detent mechanism?

A: Any general-purpose grease suitable for mechanical components can be applied to the pivot and detent mechanism regularly to ensure smooth operation.

Parts List

• (x1) Left assembly
• (x1) Right assembly
• (1) 7/64” Allen wrench

Tool List

• 7/64” Allen wrench
  • Threadlocker

IRM Moto Sparky Peg Installation Instructions

ID Description

• a 6-32 × 1-1/2″ bolts
• b Retaining clip
• c Mount
• d Footrest

Installation Instructions

1. Remove the spark plug cover from the valve cover
   • Pull on the area where the spark plug wires traverse through the plastic, pull out, and forward
2. Remove the clasp that holds the sheathing loom to the ignition coil
   • The clip will replace this functionality
3. Select the correct assembly for each side
4. Using a 7/64″ Allen key, remove the (x4) 6-32 bolts holding the retaining clip onto the Sparky assembly
   • Take note of the orientation of the retainer clip for assembly later
5. Place the Sparky Peg retaining clip into the valve cover from the back, then slide it forward until it hits the stop.
   • Notice the orientation of the retaining clip
6. Place the Sparky Peg into the valve cover
7. Using (x4) 6-32 bolts, attach the retaining clip to the Sparky Peg
   • Use threadlocker
   • Tighten bolts in a cross pattern to ensure proper peg fit
   • When bolts are tight there will still be space between the retaining clip and the mount, do not continue to tighten to try to eliminate this gap and strip the threads
8. Repeat for the other side
9. Retighten after the first ride

Care and Maintenance

1. Periodically check the tightness of the retaining clip bolts
2. Apply grease to the pivot and detent mechanism regularly

• www.irmmoto.com
• sales.irmfg@gmail.com

Documents / Resources

| IRM MOTO R1200RT Sparky Pegs [pdf] Installation Guide
R1200RT Sparky Pegs, R1200RT, Sparky Pegs, Pegs
---|---

References

• IRM Moto

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>