Canon WM01B Module User Manual
- June 6, 2024
- Canon
Table of Contents
Canon WM01B Module User Manual
This is a user manual for host product manufacturers to use when integrating
the module in a host product.
This is Limited modular approval as this module is limited to installation by
the grantee into our host systems.
This module should be installed in the host device according to the interface
specification.
The following information must be indicated on the host device of this module;
[for FCC]
Contains FCC ID: AZDWM01B
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
*If it is difficult to describe this statement on the host product due to the size, please describe in the User’s manual.
[for IC]
Contains IC: 498J-WM01B
The following statements must be described on the user manual of the host device of this module;
[for FCC]
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure of low-level RF that does not produce heating effects causes no known adverse health effects. Many studies of low-level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. This model has been tested and found to comply with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines.
Explanatory note in the manual
Only a physician or a legally certified operation should use the product.
Please do not adhere to your hands and body to an antenna part to restrain
exposure of the RF energy when conducting an X-ray examination.
This device complies with below part 15 of the FCC Rules.
Part 15 Subpart C
Part 15 Subpart E
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant (FCC Part 15.247), and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
[for IC]
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
5150-5350 MHz band is restricted to indoor operations only.
High-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.
The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure of low-level RF that does not produce heating effects causes no known adverse health effects. Many studies of low-level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. This model has been tested and found to comply with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules.
Explanatory note in the manual
Only a physician or a legally certified operation should use the product.
Please do not adhere to your hands and body to an antenna part to restrain
exposure of the RF energy when conducting an X-ray examination.
The following statement is for host manufacturer, therefore isn’t described on the user manual of the host device.
This radio transmitter (FCC: AZDWM01B/ IC: 498J-WM01B, WM01B) has been
approved by FCC and ISED to operate with the antenna types listed below with
the maximum permissible gain indicated. Antenna types not included in this
list, having a gain greater than the maximum gain indicated for that type, are
strictly prohibited for use with this device.
Antenna type: Monopole antenna (1/4 λ)
Gain: 3.4dBi (2.4GHz-2.5GHz)/3.9dBi (5.15GHz-5.85GHz)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>