ROBUS RHR40CCT3-10 Horizon 40W CCT3 Selectable Linear Light 1410mm Matt Black Installation Guide

ROBUS RHR40CCT3-10 Horizon 40W CCT3 Selectable Linear Light 1410mm Matt

Black

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES. Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent electrician

Note: Product technical information and specification may change over time without prior notification. For the latest technical information please visit our web site www.robus.com or robusdirect.com -20°C < Ta < +40°C, 220-240V ~ 50/60Hz, Class I, IP20 Luminaire is non-dimmable Suitable for mounting on a normally flammable surface.

Installation

1.  Ensure mains supply is switched off before commencing work.
2.  Remove screws holding bracket in place, expose terminals. Feed supply cable through the IP rated seal. Connect Supply : L – Brown, N- Blue and E -yellow/Green as per figure 2,3,4,5. Close bracket. Refit screws
3.  Fix the metal plate to the end of suspension kit as per figure 6,7,8,9.
4.  Mark fixing positions on the ceiling, before cutting ensure that the holes does not impinge on joists, pipe work, cables or other building services.
5.  Attach two fixing nuts onto the ceiling and screwing ensure that it is secure.
6. Attach base of suspension kit to the ceiling using the screws provided, ensure that they are secure.
7.  Adjust length of suspension wire by pressing nipple on top of suspension support, ensure that all wires are equal (tie-up excess wire) as per figure 10. Surface mounting(figure15):
8.  Fix the brackets and safety wires onto the ceiling using the screws provided.
9.  Fix other end of safety wires onto the fitting. And attach the back of fitting to the brackets ensure it locks in slots.
10.  Use the Linking bracket to extend the fitting as per figure11, 12,13,14
11.  Move switch on back of the fitting to select colour temperature: 3000K, 4000K, or 5700K. WARNING: DO NOT CHANGE CCT WHEN THE FITTING IS ON!!

RHR40CCT3-UP: HORIZON 40W CCT3 selectable up light module accessory RHRS15: HORIZON AC Silflex 1.5m cable accessory RHESUS: HORIZON 1.5m suspension kit accessory RHRLB: HORIZON Linking bracket and cover accessory Market Surveillance: These products contain light sources ‘LS Code’ of energy efficiency of Class C. RHR40CCT3-LS, 3000K Disconnect driver input and output connections. Remove screws and remove diffuser. Remove LED PCB

Information for the Product user

1. 1. Please note the requirement to dispose of Waste Electrical & Electronic Equipment separately from household waste (WEEE marked with crossed-out wheelie bin symbol).
   2. Please consider your role in contributing to re-use and recycling by returning this product at end of life to a collection centre for waste electrical equipment or a Civic Amenity site, or to a retail outlet from which you are purchasing a replacement.
   3. This equipment may contain substances that are hazardous to health and the environment if disposed of carelessly. It is important that it is separated from normal household waste and recycled in the WEEE chain
   4. The “crossed out wheelie bin symbol” on a product indicates this equipment must not be disposed of in normal household waste, but should be disposed of according to local WEEE regulations

References

• robusdirect
• ROBUS: Home to Best-in-Class LED Lighting and Customisation - Robus

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>