DM01 Genuine Steel-Line 433 MHz Three Button Keyring Remote User Manual
- June 6, 2024
- Steel-Line
Table of Contents
DM01 Genuine Steel-Line 433 MHz Three Button Keyring Remote
Function Description
- Transmitter Type：ST-L-Transmitter
- Transmitter Power : 6V (CR2016*2)
- Factory Code：Steel-Line Code
- Operating Freq : 433.92MHz
- Modulation Type : ASK
Specification
-
Learn the transmitter to the opener.
-
When opener is without limit position
• Key 1–Open / travel toward up limit position
• Key 2–Limit position confirm
• Key 3–Close / travel toward down limit position -
When the opener is with limit position
• Key 1–When the door is fully closed, press the first time to open the door, press the second time to stop, press
The third time is closing.
When the door is fully open, press the first time to close the door, press the second time to open the door, pressThe third time is a stop.When the door is in the middle, press the first time to close the door, press the second time to open the door, press The third time is a stop.
• The second and third keys have the same functions as the first keyº
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
This device may not cause harmful interference, and This device must accept
any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help. RF warning
statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>