FALCON RIDGE KAW-PROFXT-RW01 Kawasaki Pro FXT Soft Rear Window Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE KAW-PROFXT-RW01 Kawasaki Pro FXT Soft Rear Window
Instructions for Installation and Care of Kawasaki Pro FXT Soft Rear Window
KAW-PROFXT-RW01
Notice: Do not smoke inside the cab or expose the enclosure to direct
flames. Cab is Flammable.
INSTALLATION INSTRUCTION
-
Be sure to read these instructions thoroughly before opening and installing the Kawasaki Pro FXT Soft Rear Window. The installation is best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to installation.
-
Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.
-
Check over the parts included in the carton with the parts list shown below:
-
Adhesive Velcro Hook Strips: Rear Window
-
“ “ “ “ 2 each ————13”
-
“ “ “ “ 1 each ————48”
-
“ “ “ “ 1 each ————53”
-
REAR WINDOW
The rear window attaches to the movable rear panel. Before placing the rear window on the panel, adhere the 48″ adhesive strip across the top and the two 13″ strips down the sides as shown in the following pictures
-
Now line up the rear window on the panel and attach it across the top and sides. The bottom of the rear window uses the 60″ adhesive Velcro strip and should be attached to the panel the line up with the Velcro sewn along the bottom of the rear window as shown in the picture below.
Cleaning and Storage Recommendations
- Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
- It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory. On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.
- A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>