Steel-Line RD1200 Door Opener User Manual
- June 4, 2024
- Steel-Line
Table of Contents
Steel-Line RD1200 Door Opener User Manual
Service/Maintenance Reminder
Models: RD800, RD1200
IMPORTANT-
The garage door and opener must be professionally maintained and serviced
regularly in accordance with the instructions provided with the product, as a
minimum every 12 months or 2,500 cycles.
This opener is pre-programmed with a service due reminder that will provide an
audible indication that a service is recommended after 2,500 cycles.
The opener has the following three (3) service intervals: 1,500 cycles, 2,500
cycles and 3,500 cycles.
The opener will keep count of the number of operating cycles (an open and
close of the door equals one cycle). Once the opener reaches the cycle count
it will flash and beep eight (8) times, every time you open your door. This
audible alarm is a reminder that a professional service is recommended. To
reset the cycle count to zero (0) follow the instructions below.
Setting cycle count:
STEP 1.
Press and hold the “LIMIT” and “UP” buttons for 3 seconds until the UP LED flashes.
STEP 2.
Using the “UP” and “DOWN” buttons select the required cycle count notification selection in sequence:
- One beep = 1500 cycles
- Two beeps = 2500 cycles
- Three beeps = 3500 cycles
The unit will save the setting 2 seconds after selecting the desired time interval.
Is your opener beeping eight (8) times every time you open your door?
This is an important reminder that a professional garage door service is
recommended to keep your garage door and opener in optimal condition.
A poorly maintained door can cause property damage and result in serious or
fatal injury. Failure to properly maintain your garage door and opener may
void your warranty.
Please contact the company that installed your opener. You can usually find
their contact details on a sticker affixed to the back of your garage door.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>