SOMOGYI FKA 150 Wall Mounted Heater Instruction Manual

FKA 150
instruction manual

Safety and maintenance

Functions

FKA 150 Wall Mounted Heater

Safety and maintenance

WALL MOUNTED HEATER
IMPORTANT SAFETY INSTRUCTIONS
READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USE AND RETAIN IT FOR LATER REFERENCE!

WARNINGS

1. Before using the product for the first time, please read the instructions for use below and retain them for later reference. The original instructions were written in the Hungarian language.
2. Children below the age of 3 years should be kept away from the appliance, except where they are under constant supervision. Children between the age of 3 and 8 may only switch the appliance on/off provided that it has been set up and installed in the normal operating position and they are under supervision or have been instructed how to operate the appliance safely and understand the hazards associated with use. This appliance may only be used by persons with impaired physical, sensory or mental capabilities, or lacking in experience or knowledge, as well as children from the age of 8, if they are under supervision or have been given instruction concerning use of the appliance by a person responsible for their safety and they have understood the hazards associated with use. Children should not be allowed to play with the unit. Children may only clean or perform user maintenance on the appliance under supervision. WARNING: Parts of this appliance can become very hot and could cause burns. Extra care should be taken when children or handicapped persons are around.
3. Do not use this heater if it has been dropped.
4. Do not use if there are visible signs of damage to the heater.
5. Never locate the appliance directly in corners and observe the minimum installation distances indicated on Figure 2. Always observe the health and safety regulations valid in the country of use!
6. The appliance should be used as intended for warming air, not for general heating purposes.
7. The stream of hot air should not be directed straight to curtains or other flammable materials!
8. The grille at the hot air outlet may be hot.
9. Do not locate near flammable materials. (min. 100 cm)
10. When installing, take into account the material and load-bearing capacity of the wall.
11. Before powering on the appliance, make sure that the heater is stable on the wall.
12. Do not use in locations where flammable vapors or explosive dust may be released.
13. Do not use near flammable materials or in potentially explosive atmospheres!
14. Can only be operated under continuous supervision.
15. Do not operate near children without supervision.
16. Only to be used in dry, indoor conditions. Protect from humid environments (e.g. bathrooms or swimming pools)!
17. It is PROHIBITED to use the appliance near bathtubs, basins, showers, swimming pools or saunas!
18. It is prohibited to use the appliance in motor vehicles or in confined spaces (< 5 m²) such as elevators!
19. When not planning to use the appliance for an extended period of time, switch it off then remove the power plug from the outlet.
20. Always power off the heater before relocating it.
21. Do not place the heater directly under the mains socket.
22. If you notice any abnormality (e.g. unusual noise from the appliance or a burning smell), switch it off and unplug it immediately.
23. Make sure that no objects or liquids can enter the appliance through the openings.
24. To reduce the risk of electric shock, do not expose this appliance to dripping or splashing water, and do not place objects filled with liquids, such as vases on the appliance.
25. Do not place an open flame source, such as a burning candle on the appliance.
26. Protect from dust, humidity, sunlight and direct heat radiation!
27. Power off the appliance by unplugging it from the electric outlet before cleaning!
28. Do not touch the appliance or the power cable with wet hands!
29. The appliance may only be connected to properly grounded 220 – 240 V~ / 50 Hz electric wall outlets! The circuit must be protected by a 16 A circuit breaker.
30. Unwind the power cable completely!
31. Do not use extension cords or power strips to connect the appliance!
32. Do not lead the power cable on the appliance, or near the air inlet and outlet openings!
33. Do not lead the power cable under carpets, doormats, etc.!
34. The appliance should be located so as to allow easy access and removal of the power plug!
35. Lead the power cable so as to prevent it from being pulled out accidentally or tripped over.
36. The appliance is intended for household use. No industrial use is permitted!
37. Due to continuous improvements, the technical data and design may change without any prior notice.
38. The actual instruction manual can be downloaded from www.somogyi.hu website.
39. We don’t take the responsibility for printing errors that may occur and apologize for them.

CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble of modifying the unit or its accessories. In case any part is damaged, immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the manufacturer, its service facility or similarly qualified personnel.

MEANING OF SYMBOL ON APPLIANCE: DO NOT COVER!
COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE OR ELECTRIC SHOCK!

INSTALLATION

1. Before installation, carefully remove packaging, and make sure not to damage the appliance or the connecting cable. The appliance must not be operated if damaged in any way!

2. The device may only be used in dry indoor conditions!

3. To mount it on the wall, follow the steps in Figure 2.:
   a. Use a screwdriver to turn the lever on the top of the wall bracket, and then lift the bracket off the back of the heater.
   b. The free flow of warm air must be ensured for operation, so observe the specified minimum installation distances!
   c. Attach the wall bracket to the wall with dowels and 4 screws. Use dowels that match the structure of the wall and the size of the screws. Make sure the console is horizontal.
   d. Hook the bottom two holes on the back of the device onto the bracket, and then hook the top two mounting points by tilting them toward the wall.
   e. If the device is already on the wall mount, use a screwdriver to turn the lever on the top of the wall bracket back to secure the device.

4. Connect the appliance to a standard grounded wall power socket! Now the appliance is ready for operation!

CLEANING MAINTENANCE

In order to ensure optimum functioning, the appliance may require cleaning at least once a month, depending on the manner of use and degree of contamination.

1. Switch off and power off the appliance by unplugging it from the electric outlet before cleaning.
2. Allow the appliance to cool down (for at least 30 minutes).
3. Clean the protective grill using a vacuum cleaner equipped with a brush accessory.
4. Use a slightly moistened cloth to clean the appliance’s outer surface. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric components of the appliance!

TROUBLESHOOTING

Check the thermostat settings.
Overheating protection may have activated.
The overheating protection activates frequently.| Clean the appliance.

DISPOSAL
Waste equipment must be collected and disposed of separately of from household waste because it may contain components hazardous to the environment or health. Used or waste equipment may be dropped off free of charge at the point of sale, or at any distributor which sells equipment of identical nature and function. Dispose of products at a facility specializing in the collection of electronic waste. By doing so, you will protect the environment as well as the health of others and yourself. If you have any questions, contact the local waste management organization. We shall undertake the tasks pertinent to the manufacturer as prescribed in the relevant regulations and shall bear any associated costs arising.

Functions

WALL MOUNTED HEATER
FEATURES
electric heater for warming the atmosphere of indoor premises

• built-in control panel and LCD display
• rated power 1250-1500 W
• electronic thermostat
• weekly program
• frost protection function
• window opening sensor
• minimalist design
• quiet and economical operation
• wall-mountable design
• automatic switch off in case of overheating

INSTALLATION
After installation, you can control the appliance with the buttons next to the display.
Setting the exact time
The first time you switch the appliance on after a power-off, the clock indicator flashes on the display for a few seconds. Use the “►“ “◄“ buttons to select the parameter you want to set (hour/minute/day), and the “▲“ “▼“ buttons to set them. The days of the week are numbered from 1 to 7 (Monday- Sunday). If you have set the time, you can confirm it with the OK button.
You can set the time and the day at any time after pressing the MENU button, and selecting the hour with the OK button.

General use
You can switch the device on or off with the on / off button. After switching on, the appliance operates in the last used mode and the last set thermostat value.
Use the “►“ “◄“buttons to select between the modes:
– frost protection : with a thermostat value of 7 °C, the product operates in frost protection function
– comfort ****: thermostat value adjustable between 5 – 29 °C
– economy : operating at 3.5 °C lower than the set comfort temperature
– weekly program: the set comfort and the associated economy mode thermostat values assigned to each day of the week and each hour of the day

Weekly programming
The device is equipped with 7 preset programs, which you can freely change.
Preset programs:

For each program, the indicates comfort mode operation, the indicates economy mode operation. Press the MENU button and then use the “►“ “◄“ buttons to select the days of the week from 1 to 7, and the “▲“ “▼“ buttons to enter the Weekly programming menu. Use the “►“ “◄“ buttons to select the days of the week 1-7, and the “▲“ “▼“ buttons to assign a program to that day.

Modify individual programs
To modify each program, press the MENU button and then select the program you want to change on any day. You can then select the program you want to change on any day, then press and hold the OK button. The display shows 01 at the first hour of the program you want to modify. Press the “▲“ button to select comfort mode, or the “▼“ button to select economy mode to that hour. The setting then automatically skips to the next hour. You can also use the “►“ “◄“ buttons to manually select the clock you want to modify. If you have set the desired mode for 24 hours, the program will be saved automatically.

Window opening detection
If the window opening detection function is active on the product, its indicator can be read on the display ( ). To turn the function on/off, select the symbol in the menu, then press OK with the “►“ “◄“ buttons to turn it on or off. When the window opening detection is activated, the product automatically switches to frost protection mode.

In the event of overheating, the overheating protection function will switch off the appliance, for example when the air inlets and outlets are covered.
Power off the appliance by unplugging it from the electric outlet. Allow the appliance to cool (for at least 30 minutes). Check whether the air inlets and outlets are obstructed or not, and clean them if necessary. Install the appliance again. If the overheating protection activates again, power off the appliance by unplugging it from the electric outlet and contact the service facility.

SPECIFICATIONS

power supply: …………………………………………….. 220 – 240 V~ / 50 Hz
output:………………………………………………………..1250 – 1500 W
rated power: ………………………………………………..1500 W
dimensions of heater: …………………………………..69 x 44 x 9,45 cm
weight: ……………………………………………………….6,5 kg

Producer
SOMOGYI ELEKTRONIC®
www.somogyi.hu
Distribuitor: S.C. SOMOGYI ELEKTRONIC S.R.L.
Tel.: +40 264 406 488,
Fax: +40 264 406 489
www.somogyi.ro

References

• Zed d.o.o.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>