ZURU 489740 Sparkle Girlz Radio Control Car Instructions
- June 6, 2024
- ZURU
Table of Contents
Safety precautions:
- Parents: Please read the operating instructions carefully with your children prior to the first use.
- Stop the vehicle through the transmitter before picking it up.
- Keep hands, hair, and loose clothing away from the moving parts, e.g. tires and the wheel hubs, when the toy is switched on.
- Do not operate the remote-controlled vehicle on the streets. Avoid hitting people, pets, or home furnishings.
Warning: Conversion or modifications to this product not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.
Driving Tips:
- Only operate the vehicle on flat, smooth (but not slippery) and dry surfaces or low pile carpets. Hair carpet or dirt can affect the operation of the vehicle.
- Do not drive the vehicle on sand or through water or snow. If your vehicle gets wets, wipe it with a towel and allow it to dry completely.
- When the vehicle runs erratically, the problem is usually the result of interference caused by high tension wires, radios, or other remote-controlled toys running close by on the same frequency as yours. You may have to choose an alternate place to drive.
- Do not operate near concrete walls which may disturb radio signal transmission.
ON/OFF switch located on the back of the Wand, and 2 buttons at the front of the Wand; 1pc ON/OFF switch included on the Car.
- Switch wand on and light will flash. Switch the car on and the wand will connect. Light will remain on for several seconds when the wand & car are successfully connected.
- Press the up/down buttons on the front side of the wand to move the car backward/forwards.
- Pointing the wand, with the transparent star facing upwards, tilt the wand left/right to turn the car left/right whilst holding the up/down button for movement.
- Remove hand from up/down button to stop the car.
- To turn the car off, switch both the wand and car buttons to off mode.
- After 3 minutes of no operation, the car will switch to sleeping mode. Switch the car off and on again to reactivate.
- The battery is low when the light stops flashing.
- Turn the steering axle adjuster at the bottom towards “L” when the vehicle drives to the right involuntarily. If it turns left involuntarily, turn the adjuster towards “R“
Troubleshooting:
| Symptom | Cause | Solution |
|---|
The vehicle does not react or react poorly to the transmitter.
|
1)PAIRING/SYNC procedure is not yet completed or done.
-
High-frequency interference occurred near high-voltage lines, transformers, and some types of buildings.
-
The transmitter batteries are weak. 4) The toy is in standby mode.
| 1) Repeat the PAIR/SYNC procedure again. 2) Avoid these if possible or
choose another place to operate the vehicle. 3) Change the new battery in the
transmitter. 4) Switch off the toy and turn it on again.
Loss of control.|
- Out of the transmission range. 2) Before the connection of wand and car, another radio control device using the same frequency and the channel is operated near your vehicle.
| 1) The control range for the vehicle is 25 meters;
2) Move to another place where without radio frequency interference from
another device
The vehicle runs slowly, erratically or does not run
| 1) Power switch is not in the “ON” position. 2) Batteries are not installed correctly. 3) Weak batteries. 4) Haircarpet or dirt might be trapped between wheels.| 1) Switch on the power. 2) Check the battery’s polarity and connection. 3) Replace them with new ones. 4) Carefully remove the foreign materials
IMPORTANT: BATTERY SAFETY INFORMATION
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are to be removed from the product before being charged.
- Rechargeable batteries are only to be charged under adult supervision.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Batteries are to be inserted with the correct polarity (+ and -).
- Exhausted batteries are to be removed from the product.
- The supply terminals are not to be short-circuited.
- Dispose of batteries safely.
- Do not dispose of this product in a fire. The batteries inside may explode or leak.
FCC Supplier’s Declaration of Conformity
Zuru SG Remote Control Car / RCCar-Car01，RCCar-Wand01
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation. Zuru LLC 228 Nevada Street, El Segundo, CA 90245, + 310
529 4830
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference;
- This device must accept any interference, including interference that may cause undesired operation of the device.
Hereby, ZURU Inc. declares that the radio equipment 100299 is in compliance
with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address:www.zuru.com/compliance/SG-
RCCar-100299
All Rights Reserved. SPARKLE GIRLZ is a trademark of ZURU Inc. Conforms to
EN71, ASTM F963. Contents may vary
ATTENTION: Please keep this instruction as it contains important information.
For more information visit
WARNING| ATTENTION|
---|---|---
CHOKING HAZARD-Small parts.
Not for children under 3 years.
| DANGER|
Documents / Resources
| ZURU
489740 Sparkle Girlz Radio Control
Car
[pdf] Instructions
RCCWAND02, 2AVX3RCCWAND02, RCCCAR02, 2AVX3RCCCAR02, 489740, Sparkle Girlz
Radio Control Car
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>