ROBUS R8WDLCCT4-01 3000K Slogan 8W CCT Selectable Slim LED Dimmable Downlight Instruction Manual
- June 5, 2024
- ROBUS
Table of Contents
ROBUS R8WDLCCT4-01 3000K Slogan 8W CCT Selectable Slim LED Dimmable
Downlight
INSTRUCTION
SLOGAN 8W CCT SELECTABLE SLIM LED DIMMABLE DOWNLIGHT, 3000K, 4000K, 5000K, 6500K, WHITE, FLEX AND PLUG R8WDLCCT4-01 PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES. Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent electrician
Note: Product technical information and specification may change over time without prior notification. For the latest technical information please visit our web site www.robus.com.au and www.robusled.co.nz 220-240V~50/60Hz, Class II, IP44 Suitable for mounting on a normally flammable surface. See website for compatible dimmer list: www.robus.com.au /www.robusled.co.nz
Installation
- Ensure mains supply is switched off before commencing work or changing colour temperature.
- It is possible to change from recessed to a flush trim using the R7TRIMF-10, R7TRIMR-01/10 or R7TRIME-01 .
- This luminaire requires a round hole Ø86mm cut into the ceiling for correct installation.
- Before cutting, ensure that the hole does not impinge on joists, pipe work, cables or other building services.
- Move switch on top of the fitting to select colour temperature: 3000K, 4000K,5000K or 6500K
- Connect supply: Insert plug in the socket.
- Place the driver above the insulation.
- Offer luminaire up to cut-out. Hold retention spring vertically against fitting body, push fitting through the cut-out until the springs come down on the upper side of the plasterboard. Ensure that the fitting is secure and the bezel is tight against the ceiling.
WARNING: DO NOT CHANGE CCT WHEN THE FITTING IS ON!!
Safety instruction
Warning Luminaire marked as IC-4 according to ASNZS60598-2.2. IC-4 Rating only applies when luminaires are installed in a ceiling with “Mineral Glass Fibre Type Insulation”. Building insulation abutting or within 100mm horizontally of the luminaire must meet the following requirements; 90°C for luminaire rating IC-F, IC-4, IC or CA80 and 150°C for luminaire rating CA135.
- Be of a type that can maintain its dimensions and structural integrity when exposed to the maximum surface temperatures of the class of luminaire, being 90°C.
- Be of a type able to withstand a 30 second needle flame test carried out in accordance with AS/NZS 60695.11.5 with the flame applied to all surfaces of the test sample. Loose fill insulation as defined in NZS 4246 is not permitted to abut or cover this luminaire or be used anywhere near this downlight.
The installation must be carried out by a suitably qualified person.
Caution;
Recessed Luminaires may pose an increased risk of fire or property damage if
not installed according to the instructions provided. As specified in AS/NZS
60598.1, AS/NZS 60598.2.2, and AS/NZS 3000: 2007 Clause 4.5.2.3.3(a), the
fitting complies with the requirements for the F Mark, meaning that the
temperature of the fitting does not exceed 90°C when abutted to or covered
with thermal insulation material. However, the driver must be installed above
the thermal insulation material, and is labelled as such Although the fitting
may be safely covered with insulation material, we recommend that the
luminaire be abutted to but not covered with insulation material in order to
maximise the lifetime of the fitting. LED lifetime can be maximised by
maintaining as low an operating temperature as possible.
The Installation must be carried out by a qualified electrician
LED Group Australia Pty Limited Suite B, 2 Pittwin Road Tel: 07 3890 5444
Capalaba Fax: 07 3890 4777Queensland 4157 Email: purchases@robus.com
Australia Website:
www.robus.com.au LED Group Crowe Hogwarth Tel: +64
3668 5285 72 Trafalgar Square Email: nz_purchases@robus.com
NELSON 7010 Website: www.robusled.co.nz New
Zealand
Risk of Fire Required clearance from structural members and building element SCB = 0mm HCB = 0mm
Documents / Resources
|
ROBUS R8WDLCCT4-01 3000K Slogan 8W CCT Selectable Slim LED Dimmable
Downlight
[pdf] Instruction Manual
R8WDLCCT4-01, 3000K Slogan 8W CCT Selectable Slim LED Dimmable Downlight,
R8WDLCCT4-01 3000K Slogan 8W CCT Selectable Slim LED Dimmable Downlight
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>